LT Security LTK1101 Series, LTK1104 Series User Manual

LTK1101 & LTK1104 Series

Card Reader

User Manual

Card Reader User Manual

i

User Manual

About this Manual

This Manual is applicable to Card Reader.

The Manual includes instructions for using and managing the
product. Pictures, charts, images and all other information
hereinafter are for description and explanation only. The
information contained in the Manual is subject to change,
without notice, due to firmware updates or other reasons. Please
find the latest version in the company website.
Please use this user manual under the guidance of professionals.

Legal Disclaimer

REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE
OF PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS. OUR
COMPANY SHALL NOT TAKE ANY RESPONSIBILITES FOR
ABNORMAL OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES
RESULTING FROM CYBER ATTACK, HACKER ATTACK, VIRUS
INSPECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER,
OUR COMPANY WILL PROVIDE TIMELY TECHNICAL SUPPORT IF
REQUIRED.
SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL
RELEVANT LAWS IN YOUR JURISDICTION BEFORE USING THIS
PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS THE
APPLICABLE LAW. OUR COMPANY SHALL NOT BE LIABLE IN THE
EVENT THAT THIS PRODUCT IS USED WITH ILLEGITIMATE
PURPOSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND
THE APPLICABLE LAW, THE LATER PREVAILS.

Card Reader User Manual

ii

Regulatory Information

Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to
comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.

FCC Conditions

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including
interference that may cause undesired operation.

EU Conformity Statement

This product and - if applicable - the
supplied accessories too are marked with
"CE" and comply therefore with the
applicable harmonized European
standards listed under the RE Directive

2014/53/EU, the EMC Directive
2014/30/EU, the LVD Directive 2014/35/EU, the
RoHS Directive 2011/65/EU.

Card Reader User Manual

iii

2012/19/EU (WEEE directive): Products
marked with this symbol cannot be
disposed of as unsorted municipal waste in
the European Union. For proper recycling,
return this product to your local supplier
upon the purchase of equivalent new
equipment, or dispose of it at designated
collection points. For more information see:

www.recyclethis.info.

2006/66/EC (battery directive): This product
contains a battery that cannot be disposed of
as unsorted municipal waste in the European
Union. See the product documentation for
specific battery information. The battery is

marked with this symbol, which may include
lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For
proper recycling, return the battery to your supplier or to a
designated collection point. For more information see:
www.recyclethis.info.
Industry Canada ICES-003 Compliance

This device meets the CAN ICES-3 (A)/NMB-3(A) standards
requirements.

Safety Instruction

These instructions are intended to ensure that user can use the
product correctly to avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
Warnings: Neglecting any of the warnings may cause serious
injury or death.

Cautions: Neglecting any of the cautions may cause injury or
equipment damage.

Card Reader User Manual

iv

Warnings

 All the electronic operation should be strictly compliance with

the electrical safety regulations, fire prevention regulations and
other related regulations in your local region.

 Please use the power adapter, which is provided by normal

company. The power consumption cannot be less than the
required value.

 Do not connect several devices to one power adapter as

adapter overload may cause over-heat or fire hazard.

 Please make sure that the power has been disconnected before

you wire, install or dismantle the device.

 When the product is installed on wall or ceiling, the device shall

be firmly fixed.

 If smoke, odors or noise rise from the device, turn off the

power at once and unplug the power cable, and then please
contact the service center.

 If the product does not work properly, please contact your

dealer or the nearest service center. Never attempt to
disassemble the device yourself. (We shall not assume any
responsibility for problems caused by unauthorized repair or
maintenance.)

Cautions

Warnings Follow these
safeguards to prevent
serious injury or death.

Cautions Follow these
precautions to prevent potential
injury or material damage.

Card Reader User Manual

v

 Do not drop the device or subject it to physical shock, and do

not expose it to high electromagnetism radiation. Avoid the
equipment installation on vibrations surface or places subject to
shock (ignorance can cause equipment damage).

 Do not place the device in extremely hot (refer to the

specification of the device for the detailed operating
temperature), cold, dusty or damp locations, and do not expose
it to high electromagnetic radiation. The appropriate
temperature is -40℃ to 70℃.

 The device cover for indoor use shall be kept from rain and

moisture.

 Exposing the equipment to direct sun light, low ventilation or

heat source such as heater or radiator is forbidden (ignorance
can cause fire danger).

 Do not aim the device at the sun or extra bright places. A

blooming or smear may occur otherwise (which is not a
malfunction however), and affecting the endurance of sensor at
the same time.

 Please use the provided glove when open up the device cover,

avoid direct contact with the device cover, because the acidic
sweat of the fingers may erode the surface coating of the device
cover.

 Please use a soft and dry cloth when clean inside and outside

surfaces of the device cover, do not use alkaline detergents.

 Please keep all wrappers after unpack them for future use. In

case of any failure occurred, you need to return the device to
the factory with the original wrapper. Transportation without
the original wrapper may result in damage on the device and
lead to additional costs.

 Improper use or replacement of the battery may result in

hazard of explosion. Replace with the same or equivalent type
only. Dispose of used batteries according to the instructions
provided by the battery manufacturer.