Printed in Vietnam
ASSEMBLY INSTRUCTIONS
Description : 36 X 36 SQUARE DROPLEAF PED TABLE
- 1 -
Printed in Vietnam
BEFORE ASSEMB
LY
PART
LIST
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free
IMPORTANT NOTE:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched
- Remove all wrapping material, including staples & packing straps before you start to assemble
- DO NOT tighten all screws and bolts until completely assembled
- Keep all hardware parts out of reach of children
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1
C Pedestal 1 D
E Wood slide 2
B Leg 4
Mounting
Plate
1
- 2 -
Printed in Vietnam
HARDWARE LIST
NO Description
Qty Sketch
NO
Description
Qty Sketch
STEP 1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
Large Flat
1
(8.5x19mm)
Hexagon Nut
3
(M8 x13mm)
Small Flat
5
(6.5x13mm)
Medium Flat
7
(6.5x19mm)
Allen Key
9
(M4 x 80mm)
Washer
Washer
Washer
4
4
4
8
1
Large Lock
2
4
6
8
Washer
(8.5x13mm)
Wrench
(13mm)
Small Lock
Washer
(6.5x11mm)
Bolt
(M6x45mm)
4
1
12
12
Attach Legs (B) to pedestal (C) with Nuts (3), and Washers (2) and (1). Tighten with the Wrench (4) as
shown below.
- 3 -
Printed in Vietnam
STEP 2
STEP 3
Attach the mouting plate (D) on top of the pedestal (C) with washers (5) and (6), and bolts (8), as
shown below. Tighten with the Allen key (9).
Insert the wood slides (E) into the groove of the mouting plate.
Carefully place the pedestal on the bottom side of the table top. Attach the top (A) to mounting
plate with bolts (8), and washers (6) and (7). Tighten with the Allen key (9)
- 4 -
Printed in Vietnam
STEP 4
Hold the dropleaf push and slide the wooden piece from underneath the table top . To lower the
dropleaf, carefully hold the dropleaf with one hand and slide the wooden piece from underneath
the table top towards the center of the top. Then, gently lower the leaf and place in the down
position.
- 5 -
Loading...