Longshine LCS-FS6116-C User Manual

FCC Certifications

This Equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to
correct the interference at his own expense.

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received; including interference that may cause
undesired operation.

CE Mark Warning

This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55022 class A for ITE, the
essential protection requirement of Council Directive 2004/108/EC
on the approximation of the laws of the Member States relating to
electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it
may be possible that information in this document is not up-to-date.
Please check with your local distributors for the latest information.
No part of this document can be copied or reproduced in any form
without written consent from the company.

Trademarks:
All trade names and trademarks are the properties of their
respective companies.
Copyright © 2010 All Rights Reserved.

1

Introduction

This device is a powerful, high-performance Fast Ethernet switch,
with all 16 ports capable of 10 or 100Mbps auto-negotiation
operation (NWay), which means the switch could automatically
negotiate with the connected partners on the network speed and
duplex mode without bandwidth congestion issue. It is ideal for
micro-segmenting large networks into smaller, connected subnets
for improved performance, enabling the bandwidth demanding
multimedia and imaging applications. This switch also supports auto
MDI / MDI-X function. Each port could be used to connect to
another switch or hub without crossover RJ-45 cable.

Store-and-forward switching mode promises the low latency plus
eliminates all the network errors, including runt and CRC error
packets. To work under full-duplex mode, transmission and
reception of the frames can occur simultaneously without causing
collisions as well as double the network bandwidth. And polarity
correction function can correct polarity errors in the 10 BASE-T
mode.

The switch is plug and play without any software to configure and it
also fully complies with all kinds of network protocols. Moreover, it
supports IEEE 802.3az Energy Efficient Ethernet (EEE) ability to
promise operation in Low Power Idle Mode to save power
consumption.

Before you start to install the switch, check the following contents in
this package:

1. One 16-port Fast Ethernet switch

2. One power cord

3. Four rubber feet

4. Wall-mount plastic and screws

5. User’s manual

2

Key Feature

¾ Complies with 10M BASE-T specifications of the IEEE 802.3

standard

¾ Complies with 100M BASE-TX specifications of the IEEE

802.3u standard

¾ Supports back-pressure (half duplex) and flow control (IEEE

802.3x)

¾ Supports NWay protocol for speed(10/100 Mbps) and duplex

mode(Half/Full) auto-detection

¾ Supports MDI/MDI-X auto crossover and polarity correction
¾ Store-and-forward architecture filters fragment & CRC error

packets

¾ Supports 8K MAC address
¾ Supports 256K bytes packet buffer memory
¾ Supports packet length to 2048 bytes
¾ Supports IEEE 802.3az Energy Efficient Ethernet
¾ Provides a switch to turn on and turn off power
¾ Supports extensive LED indicators for network diagnostics

3

61NB-F116B0+200