Page 1
LS-LC-30D/35D FIRE SAFE USER
https://www.supplychimp.com/
MANUAL
STEP
STEP 2 – CHANGING THE USER CODE
1. OPEN THE SAFE DOOR (see STEP 1 above)
2. PRESS THE RED RESET BUTTON (located in the center of the door on the
3. WHILE THE LCD IS ALLUMINATED, ENTER YOUR NEW CODE (3-8
4. YOUR CODE IS NOW SET.
STEP 3 – CHANGING MASTER CODE
1. OPEN THE SAFE DOOR (see STEP 1 above)
1 – OPENING THE SAFE:
1. PRESS THE START KEY. THE LCD DISPLAY WILL SHOW “--------“.
2. ENTER THE ACCESS CODE. (Default code is: “0-0-0-0”)
3. PRESS THE START KEY, AND THE LCD DISPLAY WILL SHOW
“OPEN”.
4. TURN THE KNOB TO OPEN THE DOOR.
back side), THE LCD DISPLAY WILL SHOW “SET-CODE”.
DIGITS) AND PRESS THE START KEY.
• THE LCD WILL SHOW “IN”.
• YOUR NEW CODE WILL BRIEFLY FLASH ON THE LCD
2. PRESS THE SETUP BUTTON (LOCATED IN BACK OF DOOR), THE LCD
DISPLAY WILL SHOW “SET-CODE”.
3. PRESS THE START KEY, THE LCD DISPLAY WILL SHOW OLD-CODE.
4. WHILE THE LCD IS ALLUMINATED, ENTER THE CURRENT MASTER
CODE (the default is : “8-8-8-8”) AND PRESS THE START KEY (the LCD will
display “SET”.
• ENTER YOUR NEW MASTER CODE (3-8 DIGITS) - the LCD
DISPLAY will show “RE-INPUT”.
• ENTER YOUR NEW MASTER CODE AGAIN - the LCD
DISPLAY will show “IN” AND WILL BRIEFLY SHOW YOUR NEW
MASTER CODE.
YOUR MASTER CODE IS NOW SET
Page 2
SAFE FEATURES:
https://www.supplychimp.com/
• CHANGE THE BATTERIES WHEN THE LCD DISPLAY SHOWS “LO-BAT”
• THE LCD DISPLAY SHOWS ERROR IF YOU ENTER AN INCORRECT
CODE.
• IF YOU ENTER AN INCORRECT FOUR CONSECUTIVE TIMES THE LCD
DISPLAY WILL SHOW “ERROR” AND THE SAFE WILL FREEZE FOR
THREE MINUTES.
Loading...