Lippert Components CA-UR User Manual

NOTE: Rear anchors are installed in the

end of the bumper. There is no precise
mounting location since a variety of
bumpers may be installed. The general
guidelines are as follows:

Mounting location should be as flat
& vertical as possible.

1.

Be sure no moldings or bumper
caps interfere with the removable
coupler.

2.

Check back side of selected
mounting location to ensure
adequate access for tightening nut.

3.

Chose a location as far back as
possible from the front edge of
bumper while giving consideration
to the other criteria listed above and
center punch and drill a 1/8" pilot
hole then enlarge to 1/2". Install
Anchor Bolt with 2" fender washer,
lock washer & nut.

4.

Flat edges of Anchor Bolt must be
Horizontal.

Happijac Company, 505 N. Kays Dr., Kaysville, UT 84037 * [phone] * [e-mail]

inscaur110403