Lift-master C-TRICODE User Manual

INSTRUCTIONS

C-TRICODETMRECEIVER KIT

Used on “Carwash” Operators

This instruction sheet is to be used in conjunction with the Receiver instructions included with this kit. Refer to these instructions for mounting of connector to operator enclosure, for receiver mounting, wiring and programming instructions refer to receiver instructions.

CONNECTOR INSTALLATION

1. Drill .494” diameter hole in desired position on enclosure. Be sure that hole is free of burrs and chassis surface around hole is smooth and free of debris.

2. Install the connector into the hole from the outside of the enclosure so that the hex body lays flush against the enclosure.

3. Install the lock nut from the inside of the enclosure to secure connector in place. Hold the body hex stationary with a wrench. (Suggested torque 35 in. lbs.)

DISCONNECT POWER AT THE FUSE BOX BEFORE PROCEEDING.

OPERATOR MUST BE PROPERLY GROUNDED AND CONNECTED IN ACCORD ANCE WITH LOCAL ELECTRICAL CODES. NOTE:THE OPERA TOR SHOULD BE ON A SEPARATE FUSED LINE OF ADEQUATE CAPACITY.

ALL ELECTRICAL CONNECTIONS MUST BE MADE BY A QUALIFIED INDIVIDUAL.

WARNING

Insert the cable through the fitting to the desired position.

Hand-tighten the SEALING nut as far as possible. Hold the BODY hex stationary with a wrench. Using a second wrench, tighten the SEALING nut until the wire is securely held in place. (Suggested torque 35 in. lbs.)

SEALING NUT

CABLE ENTRY

ENCLOSURE (OUTSIDE)

LOCK NUT (INSIDE ENCLOSURE)

01-18359A

BODY HEX

2001, The Chamberlain Group, Inc.