Life Fitness TR9700, TR9500, TR9100 User Manual

Life Fitness Model TR9700, TR9500, TR9100 Treadmills

How To...Replace or Install Rear Roller Guards

Tools Required: Philips Screwdriver

NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.

1. Remove the Screws securing the Rear Roller Guard Assembly to the Frame.

Cover Guard

Grommet

Screw

Roller Guard, RT
Roller Guard, LT

Grommet

Screw

Configuration No. 1

2. Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model
specific).

3. Install the new Grommets (included in kit) in the Rear Roller Guard Weldment and Base Frame
locations.

4. Place new Roller Guard in position as shown with the top surface under walking belt. Align mounting
holes.

Roller Guard to be

located between belt

and deck

Align mounting holes
with grommet holes

Life Fitness Model TR9700, TR9500, TR9100 Treadmills

How To...Replace or Install Rear Roller Guards

5. Install Screws and fasten securely. Approx. 22-37 in/lbs.

Secure Mounting
Screws

6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If
needed loosen Mounting Screws, re-align Guard, and refasten securely.