Life Fitness TR91, TR95, TR97 User Manual

Life Fitness Model TR91/95/97 Series Treadmills
Bracket
Grommet
Rear
Roller
Self-Tapping
How To… Install The Roller Guard Bracket Kit
Tools required: Hex key wrench set, socket and ratchet set, drillbit set, drill, file,
and Phillips screwdriver Kit # GK58-00002-0008
1. Turn the unit power OFF at the ON/OFF switch, and then
unplug the line cord at the wall outlet.
2. Remove the REAR ROLLER GUARDS.
4. Remove the REAR ROLLER.
5. Insert the Treadmill Model appropriate TEMPLATE into
user left rear roller channel and mark hole locations on the FRAME. Flip the template and repeat for the user right rear roller channel.
6. Drill a 0.154 hole at each of the four marked locations.
7. Install a GROMMET into each ROLLER GUARD
BRACKET.
8. Install each ROLLER GUARD BRACKET using two supplied short screws.
Note: It may be necessary to file down any weld material that would prevent the ROLLER GUARD BRACKET from being mounted flush to the frame.
Rear Roller Welded Guard Tab
Tension Bolts
Rear Roller Guards
9. Re-install the REAR ROLLER. Using the supplied long
screws, re-install the REAR ROLLER GUARDS making sure the striding belt is properly adjusted and tensioned. Refer to service manual “HOW TO…Replace Striding Belt” for proper belt adjustment and tensioning.
Screws
M051-00K58-A026
Loading...