ADDENDUM To CSAFE Kit
Installation Instructions
ATTENTION INSTALLERS!
CSAFE Communication Board Installation
This addendum is to be used in conjunction with the enclosed CSAFE Installation Instruction Kit.
The CSAFE Board and its Components are identical with the CSAFE Installation Kit except as follows.
JW6
JUMPER CONFIGURATION TABLE
Jumpers Circuit Life Cycles
Rear-Drive Cross-Trainer
JW1 IN OUT IN
JW2 IN OUT IN
JW3 OUT OUT OUT
JW4 IN OUT OUT
JW5 OUT OUT OUT
JW6 IN IN IN
1. Make sure the CSAFE Board Jumpers are configured according to the JUMPER CONFIGURATION TABLE.
2. The CSAFE Board has two(2) RJ45 Connectors connected in parallel. Install the 3 ft. CNA Cable in either RJ45
port.
3. Route and locate the other end of this cable outside the shroud to where the CNA will be mounted.
Cross-Trainer, Treadmills,
and Stairclimbers
MO51-00K64-D001