Life Fitness 8211 User Manual
8211 50 LB. ADD-ON KIT
Part # 6812901
ASSEMBLY INSTRUCTIONS
Revision: 1/11/991
IMPORTANT NOTES
Please note:
* Thank you for purchasing the LIFE FITNESS 8211 50 LB ADD-ON KIT. Please read these
instructions thoroughly and keep them for future reference. This product must be assembled
on a flat, level surface to assure its proper function.
* We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your LIFE FITNESS customer service representative at (800) 328-9714.
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
1. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
2. Do not allow minors or children to play on or around this equipment.
3. Exercise with care to avoid injury.
4. If unsure of proper use of equipment, call your local LIFE FITNESS STRENGTH distributor or call the LIFE FITNESS STRENGTH customer service department at (800) 328-9714.
5. Consult your physician before beginning any exercise program.
Tools Required for Assembly
* 3/4” wrench, 9/16” wrench
* Ratchet with 3/4” and 9/16” sockets
* 7/32” Allen wrench
* Adjustable wrench
* Tape measure
Bolt Length Ruler
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH
BOLT LENGTH RULER:
1/2 1/2 1/2 1/2 1/2 1/2
0
1
2
3 4 5
2
6
PARTS LIST
KEY
1
2
3
PART #
6284501
6671001
6382301
TOWER
LAT CABLE
DESCRIPTION
25 HOLE WEIGHT STACK SHAFT
117-3/4” CABLE ASSEMBLY
WEIGHT PLATE BUSHING 10 CT
QTY
1
1
1
KEY
4
5
6
PART #
6703801
6189501
6214501
DESCRIPTION
WEIGHT STACK LABEL (lbs.)
WEIGHT STACK LABEL (1-25)
WEIGHT PLATES
QTY
.1
1
5
SHROUD
FIGURE 1
STEP 1:
• Unscrew the threaded end of the LAT CABLE (67815) from the WEIGHT STACK SHAFT of the HEAD PLATE.
• Completely remove LAT CABLE (67815) from the TOWER BRACE, PULLEY BLOCK ASSEMBLY, and TOP BOOM. See FIGURE 1.
(NOTE: It may be necessary to loosen and remove some pulleys before removing the cable.)
• Discard LAT CABLE (67815 ).
• Remove the SHROUD from TOWER for ease of assembly.
3
Loading...