Serious Steel
415101 400 LEG PRESS ADAPTER KIT
Part# 6694601
ASSEMBLY INSTRUCTIONS
II
Revision: 06/12/97
]IMPORTANT NOTES[
There is a risk assumed by individuals who use this type of equipment. To minimize risk, please
follow these rules:
1. Consult your physician before beginning any exercise program.
2. Inspect equipment daily. Tighten all loose connections and replace worn parts immediately.
Failure to do so may result in serious injury.
3. Do not allow minors or children to play on or around this equipment.
Exercise with care to avoid injury.
4.
If unsure of proper use of equipment, call your local Parabody distributor or call the
5.
Parabody customer service department at (800) 328-9714.
Please note:
* Thank you for purchasing the Parabody 415101 Leg Press Adapter Kit. Please read these
instructions thoroughly and keep them fbr future reference. Tl~:is product must be assembled
on a flat, level surface to assure its proper function.
* We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your Parabody customer service representative
at (800) 328-9714.
[Tools Required for Assembly]
* Rubber mallet or hammer
*
3/4" wrench
* 9/16" wrench
* Ratchet with 3/4" and 9/16" sockets
* 5/32" Allen wrench
* Adjustable wrench
* Tape measure
[ Bolt Length Ruler ]
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH RULER:
BOLT LENGTH
5 6
PARTS LIST
PART #
6686603
6693902
3
6694002
6694203
4
5
3116201
6
6405201
7
6467001
8
3108102
6140701
9
NOTE: The LEG PRESS ATTACHTMENT (832101) must be assembled before connecting it to the
STEP 1
¯
Slide two PAILABODY LOGO END CAPS (7) over
the FRONT LEG (1) as shown in FIGURE
PARABODY LOGO END CAP
DESCRIPTION
FRONT LEG
PULLEY BRACKET
CABLE SWIVEL
BASE CONNECTION
3-1/2" PULLEY
2" SQ. END CAP
QUICK DISCONNECT LINK
GLIDE 1 X 1"
QTY
1 10 3102501
1 11
1 12
1
2
1 15 3102918
2
1
2
PARABODY 400 HOME GYM
KEY PART #
3102802
3102801
13 3102924
14 3102904
16 6694301
6694401
17
DESCRIPTION
3/8" WASHER
3/8" LOCKNUT
1/2" LOCKNUT
3/8 X 1-3/4" BOLT
3/8 X 3" BOLT
1/2 X 3-1/4" BOLT
112-3/4" CABLE ASSY
82-1/2" CABLE ASSY
QTY
4
5
2
3
2
2
1
1
STEP 2
¯ Slide one 2" SQ. END CAP (6) into the BASE CONNECTION (4)
as shown in FIGURE 2.
FIGURE 2
STEP 3
¯ Attachtwo 1 X 1" GLIDES (9) tothetop of puLLEY BRACKET
(2) as shown in FIGURE
FIGURE 3