Design Guide 2011
Freestanding / Semi Built In Models 30", 36" and 60"
Welcome
Liebherr's engineering excellence in Germany provides the largest
selection of freezers, refrigerators and wine refrigerators worldwide.
Liebherr-appliances consistently specializes in the manufacturing of high
quality freezers and refrigerators. With more than 300 basic models, we have
the widest selection in the world. Liebherr appliances feature premium quality,
numerous innovative product ideas and advanced design. Liebherr freezers and
refrigerators are manufactured at three modern production plants:
Liebherr Marica in Bulgaria, Liebherr-Hausgeräte Ochsenhausen GmbH in
Germany and the Liebherr-Hausgeräte Lienz GmbH in Austria.
The appliances for the North American market are produced in Austria and in
Germany.
Liebherr is commited to the protection of the environment and recognizes it
as a critical priority. To guarantee an optimum and consistent implementation,
all ecological aspects were observed and integrated into the quality control of
Liebherr in compliance with DIN EN ISO 9001.
Liebherr's Commitment to the Environment
The components of Liebherr products can be recycled when the necessary
resources are applied. A concern for the environment and a desire to protect
resources has lead to increased levels of recycling year after year. When Liebherr
manufactures products, it is essential that the recyclable recovery rate of the
materials we use constantly increases.
Recycling is a common goal among all manufacturers, municipalities and
recycling companies to protect our environment. Protecting the environment
and producing products which have a low impact on the environment, is one
of Liebherr's core values. Whether you are replacing a unit or starting fresh,
remember to dispose of your old appliance in an environmentally safe and
friendly manner.
Introduction
LIEBHERR WARRANTY PLAN
FULL TWO YEAR WARRANTY - For two years from the date of original purchase, your Liebherr Warranty
covers all parts and labor to repair or replace any part of the product which proves to be defective in materials or workmanship.
FULL FIVE YEAR WARRANTY - For five years from the date of original purchase, your Liebherr Warranty
covers all parts and labor to repair or replace any components that prove to be defective in materials or
workmanship in the sealed system. The "Sealed System" means only the compressor, condenser, evaporator, drier and all connecting tubing.
LIMITED 6TH THROUGH 12TH YEAR WARRANTY - From the 6th through 12th year from the date of original purchase, your Liebherr Warranty covers all parts that prove to be defective in materials or workmanship
in the sealed system (parts only).
For Service and Parts in the U.S.:
Liebherr Service Center
15545 N. 77th Street
Scottsdale, AZ 85260
Phone: (480) 998-0141
Fax: (480) 998-7877
Toll Free: 1-866-LIEBHERR or
1-866-543-2437
www.liebherr-appliances.com
For Service and Parts in Canada:
Euro Parts
579 Campbell Street,
P.O. Box 759,
Lucknow, Ontario, N0G 2H0
Phone: (519)528-5005
Fax: (519)528-5001
Toll Free:
1-888-Liebherr or
1-888-543-2437
www.euro-parts.ca
Contents
General Remarks
Safety Warnings I
Electrical Requirements & Safety II
IceMaker (if equipped) III
Area Requirements IV
Safety Regulations V
Freestanding/Semi Built In Models
30" and 60" Models: CS 1400, CS 16.., SBS 32S1 1
36" Models: CS 2062, CBS 2062, CS 2060, CS 2061 3
Unit Dimensions 5
Cabinet Opening Dimensions 7
Ventilation Requirements 9
Front Clearance CS/CBS 2062 11
Front Clearance CS 2060, CS 2061 12
Door Swing Clearance CS/CBS 2062 13
Door Swing Clearance CS 2060, CS 2061 14
General Remarks
I. Safety Warnings
PLEASE READ AND FOLLOW THESE INSTRUCTIONS
This design guide contains Warning and Caution statements. This information is important for safe and
efficient installation.
This design guide is not replacing the use and care manual which contains important information on how to use Liebherr appliances.
Always read and follow all Warning and Caution statements!
Warning indicates a potentially hazardous situation
which, if not avoided,
could result in death or serious injury.
Caution indicates a potentially hazardous situation
which, if not avoided,
may result in minor or moderate injury.
IMPORTANT
This highlights information that is especially relevant
to a problem-free installation and operation.
Make sure incoming voltage is the same as the unit rating.
To reduce the risk of fire, electric shock, or personal injury, the installation work and electrical wiring must be done by a
qualified electrician in accordance with all applicable codes and standards, including fire rated construction.
To the Installer
It is very important that the guidelines and instructions are followed in this design guide to ensure proper installation
and operation of the unit. The Installation Guidelines section contains important information for making sure the installation is correct. Read and understand all the information and installation guidelines in this manual before the unit is
installed.
It is also very important to know the Safety Information.
General Remarks
II. Electrical Requirements & Safety
A 115 Volt, 60 Hz, 10 Amp (15 Amp for side-by-side
installation) fused electrical supply is required. We recommend using a dedicated circuit for these appliances
to prevent electrical overload. Comply with the National
Electrical Code as well as local codes and ordinances
when installing the receptacle.
The power cord is equipped with a three-prong (grounding) plug for your protection against possible shock hazards. To maintain this protection:
• Do not modify the plug by removing the round grounding prong.
• Do not use a power cord that is frayed or damaged.
Do not ground to a gas pipe. Check with a
qualified electrician if you are not sure the
appliance is properly grounded. Do not have
a fuse in the neutral or grounding circuit.
III. IceMaker (if equipped)
The icemaker is located in the freezer compartment.
It must be connected to the water supply to function
properly. The appliance must be level for the icemaker to
function properly.
The water supply pressure requirements are different
based on whether or not the supplied Liebherr water filter
is installed. With the filter installed, the pressure must be
in the range of 40-90 psi (2.8-6.2 bar). Without the filter
installed the acceptable pressure range is 22-87 psi (1.5-6
bar).
Use a 1/4" OD copper line to connect the water supply to
the solenoid valve. This is not supplied with the appliance.
If you have hard water, we recommend you install a
water softener. Also, a filter must be installed if the water
contains solids such as sand. All equipment and devices
used to supply the water to the appliance must comply
with the current regulations for your geographical area.
Safety Instructions and Warnings
• Do not attach the water source while the appliance is
connected to an electrical outlet.
ELECTROCUTION HAZARD
Electrical Grounding Required. This
appliance is equipped with a threeprong(grounding) polarized plug for your
protection against possible shock hazards.
• DO NOT remove the round grounding
prong from the plug.
• DO NOT use a two-prong grounding
adapter.
• DO NOT use an extension cord to connect
power to the unit.
• A shut-off valve, must be installed between the hose
line and the main water supply so that the water supply
can be stopped if necessary. Do not install the shut-off
valve behind the refrigeration unit.
• The connection to the water supply may only be made
by a trained and licensed plumber.
• The water quality must comply with the drinking water
regulations for the geographical area where the appliance is located.
• The icemaker is designed exclusively to make ice
cubes in quantities needed by a household and may
only be operated with water appropriate for this purpose.
• All repairs and work on the icemaker may only be done
by customer service personnel or other trained personnel.
• The manufacturer cannot accept liability for damage
caused by equipment or water lines between the solenoid valve and the water supply.
Loading...