2
SAFETY PRECAUTIONS
ENGLISH
SAFETY PRECAUTIONS
To prevent injury to the user or other people
and property damage, the following instructions must be followed.
•
Incorrect operation due to ignoring instruction
will cause harm or damage. The seriousness
is classified by the following indications.
WARNING
This symbol indicates the possibility of death
or serious injury.
CAUTION
This symbol indicates the possibility of injury
or damage.
• Meanings of symbols used in this manual
are as shown below.
WARNING
Installation
• Don't touch with the hands while the
power is on.
- There is risk of fire or electric shock.
• Use standard parts(connector).
- Do not disassemble or repair the product.
There is risk of fire or electric shock.
•
For electrical work, contact the dealer, seller, a qualified electrician, or an Authorized Service Center.
- Do not disassemble or repair the product.
There is risk of fire or electric shock.
• Use the correctly rated breaker or fuse.
- There is risk of fire or electric shock.
• Do not install, remove, or re-install the unit
by yourself (customer).
- There is risk of fire, electric shock, explosion, or injury.
• For installation, always contact the dealer
or an Authorized Service Center.
- There is risk of fire, electric shock, explo-
sion, or injury.
Operation
•
When the product is soaked (flooded or submerged), contact an Authorized Service Center.
- There is risk of fire or electric shock.
•
Be cautious that water could not enter the product.
- There is risk of fire, electric shock, or prod-
uct damage.
PART DESCRIPTION
PP485B00K
!
!
!
NOTE
!
RS-485 is one of the international interface standards for serial communication.
Modbus Converter
LED01G, 02G, 03G: Communication Status LED
LED1:RS-485 Status LED
CN_PWR: 220V~ Connector
+10V: DC 10 V Terminal
GND: Ground
BUS_A: *RS-485 (+) Terminal (Refer to
note)
BUS_B: RS-485 (-) Terminal
DIP Switch: Product Selection (Refer to
the DIP Switch Configuration)
CN_OUT: Outdoor Unit Connector
Reset Switch: Modbus Converter Reset
NOTE
!
Install and use by qualified personnel only.