enclosure that may be of sucient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK
HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN
OR MOISTURE.
WARNING: Do not install this equipment in a
conned space such as a book case or similar unit.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This lightning ash with arrowhead
symbol within an equilateral triangle
is intended to alert the user to the
presence of uninsulated dangerous
voltage within the product’s
is intended to alert the user to the
presence of important operating
and maintenance (servicing)
instructions in the literature
accompanying the product.
CAUTION concerning the Power Cord
Most appliances recommend they be placed upon
a dedicated circuit;
That is, a single outlet circuit which powers only
that appliance and has no additional outlets or
branch circuits. Check the specication page of this
owner’s manual to be certain. Do not overload wall
outlets. Overloaded wall outlets, loose or damaged
wall outlets, extension cords, frayed power cords, or
damaged or cracked wire insulation are dangerous.
Any of these conditions could result in electric
shock or re. Periodically examine the cord of your
appliance, and if its appearance indicates damage
or deterioration, unplug it, discontinue use of the
appliance, and have the cord replaced with an
exact replacement part by an authorized service
center. Protect the power cord from physical or
mechanical abuse, such as being twisted, kinked,
pinched, closed in a door, or walked upon. Pay
particular attention to plugs, wall outlets, and
the point where the cord exits the appliance. To
disconnect power from the mains, pull out the
mains cord plug. When installing the product,
ensure that the plug is easily accessible.
NOTICE : For safety marking information including
product identication and supply ratings, please
refer to the main label on the bottom of the
apparatus.
This device is equipped with a portable battery or
accumulator.
Safety way to remove the battery or the
battery from the equipment: Remove the
old battery or battery pack, follow the steps
in reverse order than the assembly. To prevent
contamination of the environment and bring on
possible threat to human and animal health, the
old battery or the battery put it in the appropriate
container at designated collection points. Do
not dispose of batteries or battery together with
other waste. It is recommended that you use
local, free reimbursement systems batteries and
accumulators. The battery shall not be exposed to
excessive heat such as sunshine, re or the like.
CAUTION: The apparatus shall not be exposed to
water (dripping or splashing) and no objects lled
with liquids, such as vases, shall be placed on the
apparatus.
Disposal of your old appliance
1. When this crossed-out wheeled bin
symbol is attached to a product it
means the product is covered by
the European Directive 2002/96/EC.
2. All electrical and electronic products
should be disposed of separately
from the municipal waste stream
via designated collection facilities
appointed by the government or
the local authorities.
3. The correct disposal of your
old appliance will help prevent
potential negative consequences
for the environment and human
health.
4. For more detailed information about
disposal of your old appliance,
please contact your city office,
waste disposal service or the shop
where you purchased the product.
Disposal of waste batteries/accumulators
1. When this crossed-out wheeled
bin symbol is attached to batteries/
accumulators of Your product
it means they are covered by
European Directive 2006/66/EC.
2. This symbol may be combined with
chemical symbols for mercury(Hg),
cadmium(Cd) or lead(Pb) if the
battery Contains more that 0.0005%
of mercury,0.002% of cadmium or
0.004% of lead.
3. All batteries/accumulators should
be disposed separately from
the municipal waste stream via
designated collection facilities
appointed by the government or
the local authorities.
4. The correct disposal of Your old
batteries/accumulators will help
to prevent potential negative
consequences for the environment,
animal and human health.
5. For more detailed information
about disposal of Your old batteries/
accumulators, please contact Your
city office, waste disposal service or
the shop where You purchased the
product.
LG Electronics hereby declares that this/
these product(s) is/are in compliance
with the essential requirements and
other relevant provisions of Directive
2004/108/EC, 2006/95/EC and
2009/125/EC.
European Standards Centre:
Krijgsman 1, 1186 DM Amstelveen The
Netherlands
Please note that this is NOT a Customer
Service contact point. For Customer
Service Information, see Warranty
Card or contact the dealer that you
purchased this product.
2 Safety Information
5 Unique Features
5 – Made for iPod/iPhone
5 – Portable In
5 – Alarm
5 – Radio(FM)
5 – Time Sync
5 Accessories
5 Introduction
5 – Symbol Used in this Manual
6 Front panel
7 Back panel
8 Connecting the AC adapter
2 Operating
9 Overall Operation
10 Basic Operations
10 – iPod/iPhone Operations
10 – Compatible iPod/iPhone
11 Setting the Clock
11 – Using your unit as an alarm clock
11 – SNOOZE
11 – Dimmer
12 – Sleep Timer Setting
12 Radio Operations
12 – Antenna Connection
13 – Presetting the Radio Stations
13 Advanced Operation
13 – Listening to music from your external
device
3 Troubleshooting
14 Troubleshooting
4 Appendix
15 Trademarks and Licenses
16 Specifications
17 Handling the Unit
1. Connect the supplied AC power cord to the AC
adapter.
2.Connect the AC adapter cable to DC.IN adapter
input.
3. Plug the AC power cord into an AC outlet. Then
the unit goes into standby mode.
Caution
>
Only use the AC adapter supplied with this
device. Do not use a power supply from
another device or manufacturer. Using any
other power cable or power supply may cause
damage to the device and void your warranty.
During playback, press twice
briey to step back to the
previous le.
Press and hold / during
playback and release it at the
point you want to listen to.
Press D/Pr.
Note
,
yIf this unit displays an error message, follow
the message. An error message “ERR”.
- Your iPod/iPhone is not connected firmly.
- This unit recognizes your iPod/iPhone as
an unknown device.
- Your iPod/iPhone is exceptionally low in
power.
The battery needs to be charged.
/
If you charge the battery while iPod/
/
iPhone is extremely low in power, it
may take longer to be charged.
yDepending on your iPod/ iPhone ’s software
version, it may not be possible to control
your iPod/iPhone from this unit. We
recommend installing the latest software
version.
yIf you use an application, make a call, or
send and receive SMS text message, etc. on
iPod touch or iPhone, disconnect it from
iPod/iPhone dock of this unit and then use
it.
yIf you have a problem with your iPod/
iPhone, please visitwww.apple.com/
support.
yIn standby mode, you can charge your iPod/
iPhone by connecting it to iPod/iPhone
Dock.
yYou may need additional operation for iPod
touch or iPhone, for example “unlock” by
draging the slider.
Operating11
Setting the Clock
Connect the iPod/iPhone rmly. Then the clock
setting in the display window will synchronize with
your iPod/iPhone.
After the unit synchronized with your iPod/iPhone
for clock setting, there will be a time dierence
between the iPod/iPhone and the unit . In standby
mode, the clock won’t synchronized with your
iPod/iPhone.
Using your unit as an alarm
clock
1. Turn the unit on or off.
2. Press and hold ALARM to set the alarm
function.
3. The alarm sound sources blinks. (FM(TUNER)/
IPOD). While each of sound sources blinks,
select the one you want by pressing D/Pr.
If you select FM(TUNER) mode, you can select
the station you set before by pressing / .
4. “ON (TIME)” setting is displayed.
The hour setting blinks. Press / to select
the hour and then press D/Pr to save.
5. The minute setting blinks. Press / to
select the minute and then press D/Pr to save.
6. The volume settings blinks. Press / to
change the volume and then press D/Pr to
save.
7. You can check the setting status.
8. If you want to reset the alarm, repeat steps 2-6.
2
Operating
SNOOZE
While alarm activates, snooze function wakes you
up every 10 minutes if you press SNOOZE/SLEEP. If
the time you set is up, the unit turns on
automatically and the alarm function works. If you
press SNOOZE/SLEEP, the alarm function stops
working. “ZZZ” and “ ” will blink. The alarm sounds
again in 10 minutes.
Dimmer
Press SNOOZE/SLEEP once. The display window
will be darkened by half. To cancel it, press
SNOOZE/SLEEP repeatedly until the display
window get bright.
Before tuning, make sure that you have turned
down the volume.
1. Press
display window.
2. Select the desired frequency by using / .
3. Press and hold D/Pr . A preset number will blink
in the display window.
4. Press / to select the preset number you
want.
5. Press D/Pr. The station is stored.
6. Repeat the steps 2 to 5 to store other stations.
7. To listen a preset station, press D/Pr and then
/ to select a preset station.
• If all stations have already been preset,
“FULL” will appear in the display window for
a moment and then a preset number will
blink. To change the preset number, repeat
the steps 4-5.
• You can not delete preset stations.
• Although all stations were preset, you can
preset a station by overwriting the previous
station.
• While listening to radio if you press and
hold D/Pr , a preset number you listened to
lastly will blink rst to overwrite the previous
station.
• While listening to a preset station if you
want to change it’s preset number at a
same frequency, press and hold D/Pr. And
then change a preset number by pressing
repeatedly until FM appears in the
P/1
Note
,
/ .
Advanced Operation
Listening to music from your
external device
The unit can be used to play the music from many
types of external device. (Portable cable is not
supplied as an accessory with this unit.)
1. Connect the external device to the PORT.IN
connector of the unit.
2. Turn the power on by pressing
3. Select the PORT (PORTABLE) function by pressing
4. Turn the external device on and start playing it.
“Made for iPod” and “Made for iPhone” mean
that an electronic accessory has been designed
to connect specically to iPod or iPhone
respectively, and has been certied by the
developer to meet Apple performance standards.
Apple is not responsible for the operation of
this device or its compliance with safety and
regulatory standards.
Please note that the use of this accessory with
iPod, iPhone may aect wireless performance.
Please save the original shipping carton and
packing materials. If you need to ship the unit, for
maximum protection, re-pack the unit as it was
originally packed at the factory.
Keeping the exterior surfaces clean
Do not use volatile liquids such as insecticide spray
near the unit.
Wiping with strong pressure may damage the
surface.
Do not leave rubber or plastic products in contact
with the unit for a long period of time.
Cleaning the unit
To clean the player, use a soft, dry cloth. If the
surfaces are extremely dirty, use a soft cloth lightly
moistened with a mild detergent solution. Do not
use strong solvents such as alcohol, benzine, or
thinner, as these might damage the surface of the
unit.