|
|
LENNOX HEARTH PRODUCTS |
|
|
KITS AND ACCESSORIES |
750,202M |
DECORATIVE UPPER AND LOWER GRILLE KITS |
|
REV. NC 02/2006 |
CHARCOAL & SATIN PEWTER |
|
|
|
|
|
|
|
INSTALLATION INSTRUCTIONS FOR UPPER AND LOWER GRILLE KITS
FOR USE WITH LENNOX™ 35/40/45 GAS FIREPLACES
UPPER GRILLE KITS - SUNRISE
Cat. No.# |
Model |
Description |
Model Series |
|
|
|
|
H3565 |
SUGK35C |
35” Charcoal |
MPD3530, MPD35ST, |
|
|
|
|
H3567 |
SUGK35SP |
35” Satin Pewter |
MPB-35ST & EDV3530 |
|
|||
|
|
|
|
H3573 |
SUGK40C |
40” Charcoal |
EDV4035, EDVST, |
|
|
|
|
|
|
|
|
H3575 |
SUGK40SP |
40” Satin Pewter |
MPD4035, EBVST |
|
|
|
|
H3581 |
SUGK45C |
45” Charcoal |
EDV4540, |
|
|
|
|
H3583 |
SUGK45SP |
45” Satin Pewter |
MPD4540 |
|
|||
|
|
|
|
|
|
LOWER GRILLE KITS |
- SUNRISE |
|
|
|
|
|
|
Cat. No.# |
Model |
|
Description |
Model Series |
|
|
|
|
|
H3569 |
SLGK35C |
|
35” Charcoal |
MPD3530, MPD35ST, |
|
|
|
|
|
H3571 |
SLGK35SP |
|
35” Satin Pewter |
MPB-35ST & EDV3530 |
|
|
|||
|
|
|
|
|
H3577 |
SLGK40C |
|
40” Charcoal |
EDV4035, EDVST, |
|
|
|
|
|
H3579 |
SLGK40SP |
|
40” Satin Pewter |
MPD4035, EBVST |
|
|
|
|
|
H3585 |
SLGK45C |
|
45” Charcoal |
EDV4540, |
|
|
|
|
|
H3587 |
SLGK45SP |
|
45” Satin Pewter |
MPD4540 |
|
|
|||
|
|
|
|
|
UPPER GRILLE KITS - CRESCENTS
Cat. No.# |
Model |
Description |
Model Series |
|
|
|
|
H3541 |
CUGK35C |
35” Charcoal |
MPD3530, MPD35ST, |
|
|
|
|
H3543 |
CUGK35SP |
35” Satin Pewter |
MPB-35ST & EDV3530 |
|
|||
|
|
|
|
H3549 |
CUGK40C |
40” Charcoal |
EDV4035, EDVST, |
|
|
|
|
H3551 |
CUGK40SP |
40” Satin Pewter |
MPD4035, EBVST |
|
|
|
|
H3557 |
CUGK45C |
45” Charcoal |
EDV4540, |
|
|
|
|
H3559 |
CUGK45SP |
45” Satin Pewter |
MPD4540 |
|
|||
|
|
|
|
LOWER GRILLE KITS - CRESCENTS
Cat. No.# |
Model |
Description |
Model Series |
|
|
|
|
|
|
H3545 |
CLGK35C |
35” Charcoal |
MPD3530, MPD35ST, |
|
|
|
|
||
H3547 |
CLGK35SP |
35” Satin Pewter |
MPB-35ST & EDV3530 |
|
|
|
|
|
|
H3553 |
CLGK40C |
40” Charcoal |
EDV4035, EDVST, |
|
|
|
|
||
H3555 |
CLGK40SP |
40” Satin Pewter |
MPD4035, EBVST |
|
|
||||
|
|
|
|
|
H3561 |
CLGK45C |
45” Charcoal |
EDV4540, |
|
|
|
|
||
H3563 |
CLGK45SP |
45” Satin Pewter |
||
MPD4540 |
||||
|
|
|
|
KIT CONTENTS
ITEM |
QUANTITY |
DESCRIPTION |
|
|
|
1 |
1 ea. |
Grill, Upper or Lower |
|
|
|
2 |
1 ea. |
Instruction Sheet |
|
|
|
Table 1 - Refer to Figure 1
Notes:
• |
The upper and lower grilles are ordered |
|
|
separately. |
|
• |
Only the lower grilles include knobs (see 2 |
Figure 1 |
|
knobs shown on Crescent Style, Figure 1). |
|
Sunrise Style (upper grille shown)
Crescent Style (lower grille shown)
Knobs
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. |
1 |
Read and understand all instructions and warnings in this document before beginning the installation.
TOOLS REQUIRED
Phillips Screwdriver
Cutting Pliers (required for modesty panels with side locating tabs only as shown in Figure 6)
GENERAL INFORMATION
These decorative grilles are offered in four attractive finishes and fit on the face of the appliance in place of the standard louvers or radiant panels. If you encounter any problems, need clarification of these instructions or are not qualified to properly install this kit, contact you local distributor or dealer.
WARNINGS
• Hot! Do not touch! These decorative grilles are NOT heat guards. Carefully supervise children in the same room as appliance.
•The lower Grille covering the controls will become hot during operation. Use care when removing the grille to access the controls and make sure to place the grille on a surface that is non-combustible or will not be damaged by high temperatures.
•INSTALL THIS KIT ONLY WHEN THE FIREPLACE IS OFF AND COLD!
INSTALLATION INSTRUCTIONS:
1.Remove Louvered or Radiant Panel/Hood Assembly -
Upper Panel - Remove the upper louvered or radiant panel/hood assembly by pulling the assembly up and out (see Figure 2). In instances where the radiant panel is used and it is framed in with tile or other approved material, the hood must still be removed by firmly pulling it forward until it releases from the receiving brackets.
Top Panel
Louvered |
Removed |
Trim Panels will |
Panels |
|
be either Lou- |
|
|
vered Panels or |
|
|
Radiant Panels. |
Radiant
Panels
Figure 2 - Remove Upper and/or Lower Panel(s)
Lower Panel - Remove the lower louvered or radiant panel assemby as follows:
•Hinged Panel (see Figure 3) - Gently depress the outer top corners of the louvered Control Compartment Access Panel until the spring-loaded magnetic catches "pop" it free, allowing it to swing out and down to open. With the panel in the open position, depress the spring-loaded hinge pin on left side until it disengages from the left cabinet panel hole. Pull panel away from fireplace.
Hinge Pin |
Latch for |
Glass Door |
Control Compartment |
Access panel |
Figure 3 - Remove Hinged Lower Panel |
•Hooked Panel (see Figure 4) - Remove the panel by gently lifting it upward until the hook catches on boths sides clear the locating slots. Then pull door out to remove.
OPENING CONTROL COMPARTMENT DOOR
Lift the Lower Control Compartment
Door up and pull out to remove.
Hook Catch
Control Valve |
Out |
|
Up
Lower Control
Compartment Door
Figure 4 - Remove Hooked Lower Panel
2 |
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. |