Lenco MDV-15 User Manual

MDV-15

DVD MICOR HI-FI SYSTEM WITH

CASSETTE, USB AND CARDREADER

INSTRUCTION MANUAL

For information and support, www.lenco.eu

FOREWORD

THANKS Dear Customer, May we take this opportunity to thank you for purchasing this player. We strongly recommend that you carefully study the User Manual before attempting to operate the unit and that you note the listed precautions.

1. Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation.

2. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-clothes, curtains, etc.

3. No naked flame sources, such as lighted candles should not be placed on the apparatus.

4. It shall not be exposed to dripping or flashing and that no objects with liquids, such as vases, shall be placed on the apparatus.

5. Do not place apparatus in closed bookcases or racks without proper ventilation.

6. Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable.

7. Always place batteries in the correct polarization into electrical components. Danger of explosion if batteries in incorrectly replace. Replace only with the same or equivalent type. Do not mix old and new batteries. Take attention to the

environment

aspects of battery disposal.

8. Invisible laser radiation when open and interlocks defeated. Avoid exposure to beam of laser.

9. Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection system or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

ACCESSORIES

CONTENT

FOREWORD.............................................................................................................1

CONTENT.................................................................................................................2

WARNING.................................................................................................................2

PANELS.....................................................................................................................3

REMOTE CONTROL...............................................................................................4

CONNECT TO THE TV-SET....................................................................................5

CONNECT TO THE AMPLIFIER............................................................................6

SYSTEM CONNECTION.........................................................................................7

BASIC OPERATION...........................................................................................8-14

MENU SETUP....................................................................................................15-19

RADIO OPERATION..............................................................................................20

CASSETTE OPERATION.......................................................................................21

SPECIFICATION.....................................................................................................22

TROUBLE SHOOTING..........................................................................................23

WARNING

Please read and understand all the warnings given in the following and those marked on the unit. This unit has been designed and manufactured to assure personal safety.

Only use the power by sign on User Manual or system.

Avoid direct sunshine and nearing heater.

Protect power cable: avoid high pressure and stamp on; do not pull & bend excessively.

Keep the unit and power plug away from water.

Never open the cover, avoid metals dropping in, such as needle, hairpin, coin etc.

Unplug the set from the outlet when you do not use it for a long time.

PANELS

1. DISPLAY SCREEN

2. STANDBY BUTTON

3. VOLUME+/- KNOB

4. FM BUTTON

5. TAPE BUTTON

6. AUDIO BUTTON

7. REMOTE CONTROL SENSOR

8. DVD BUTTON

9. PLAY/ENTER BUTTON

10. STOP BUTTON

11. TAPE FAST FORWARD BUTTON

12. TAPE PAUSE BUTTON

13. TAPE STOP/OPEN BUTTON

14. TAPE FAST REWIND

15. TAPE RECORD BUTTON

16. TAPE PLAY BUTTON

17. EARPHONE JACK

18. USB PROT

19. CARD PORT

1. FM ANTENNA INTERFACES

2. L/R AUDIO INPUT

3. L/R AUDIO OUTPUT

4. COAXIAL OUTPUT

5. L/R SPEAKER OUTPUT

6. OPTICAL FIBER OUTPUT

7. VIDEO OUTPUT

8. S-VIDEO OUTPUT

9. Y, Pb/Cb, Pr/Cr COMPONENT OUTPUT

10. SCART

11. POWER ON/OFF

12. POWER SUPPLY INPUT

REMOTE CONTROL

NOTE:

1. Turn on the player, insert the batteries into the remote control, and direct the remote control at the remote sensor on the front panel.

2. Remote control functions at the distance of 7 m (not more) from the player.

3. If the remote control sensor or IR-radiator is closed, the remote control will not operate or there will be an interference.

4. Interference from the high tension appliances, generating high frequency signal can strongly influence the work of the remote control.

CONNECT TO THE TV-SET

1. If your TV-set has AV input, use the AV cable to connect the player to the TV-set. After you make sure the connection is right, give AV status to the TV-set in the settings.

2. If your TV-set has S-video input, use S-video cable to connect the player to the TV-set. This type of connection provide the best quality of picture.

3. If your TV-set has Pb/Cb, Y, Pr/Cr input, use six headed jack cable to connect the player to the TV-set. This type of connection make the picture more natural.

4. This unit has an output interface for Scart output, which can directly be connected with TV-set.

NOTES:

1. Before connecting the player to the TV-set, turn off and unplug the both units.

2. During playing a disc we recommend to change settings of the player in order to make compatible with the TV-set.

3. You can connect the player the TV-set in different ways. Choose only one of them.

Multiple connections negatively influent the source and picture quality.

4. Do not turn ON/OFF the player very often. The interval must be min. 3 seconds.

5. Do not use digital coaxial or optical output of the player and analogue output at the

same time.

CONNECT TO THE AMPLIFIER

Digital audio output setting

Connect coaxial or optical output of the player to the corresponding inputs of the amplifier. During playing a disc or stop, press the SETUP button on the remote control to open the DVD menu page. Use direction buttons to move to the Audio setup page； Also, move the cursor downwards to Digital audio setup by using the direction buttons; then use the Right direction button again to move to SPDIF setup. Select the digital output and set SPDIF/RAW or SPDIF/PCM. Then press the PLAY/ENTER button to save the selected value. Finally, press the SETUP button again to exit the setup menu.

SYSTEM CONNECTION

Before connection of the acoustic equipment, pay attention to the picture below. Each connection must be safe and firm. Connect the power at last.

+ 16 hidden pages