Lenco MCI-400 V1.0 User Manual

V1.0

MCI-400

MUSIC CENTER WITH iPod DOCKING STATION, CASSETTE, FM RADIO, CD/MP3 PLAYER

AND USB- & CARDSLOT

INSTRUCTION MANUAL

For information and support, www.lenco.eu

LOCATION OF CONTROLS

1) CD DOOR 15) MAIN UNIT ON / OFF BUTTON

2) LCD DISPLAY 16) FUNCTION BUTTON

3) VOLUME UP/DOWN BUTTON 17) MEMORY/CLOCK ADJUST BUTTON

4) CD DOOR OPEN/CLOSE BUTTON 18) MP3 FOLDER UP/ PRE-UP

5) PRESE BUTTON 19) ST-MONO / PLAY/PAUSE BUTTON

6) ALARM BUTTON 20) REMOTE SENSOR

7) PLAY MODE BUTTON 21) STANDBY LED INDICATOR

8) 3.5MM STEREO HEADPHONE JACK 22) USB SOCKET

9) STOP BUTTON 23) iPod DOCKING STATION

10) SKIP / TUNING UP /DOWN BUTTON 24) SD/MMC CARD SLOT

11) CASSETTE DECK DOOR 25) SPEAKER OUT TERMINAL (L/R)

12) CASSETTE CONTROL KEY 26) FM 75 OHM ANTENNA JACK
RECORD KEY 27) SUB-WOOFER OUT JACK

PLAYBACK KEY 28) AC POWER CORD OF MAIN UNIT

REWIND KEY 29) SUB-WOOFER VOLUME CONTROL

FAST FORWARD KEY 30) AC POWER CORD OF SUB-WOOFER UNIT

STO/EJECT KEY 31) SUB-WOOFER IN JACK

PAUSE KEY

13) CASSETTE KEY DUST COVER

14) SUB-WOOFER POWER ON/OFF BUTTON/INDICATOR

E-2

CAUTION:

USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED
HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.

IMPORTANT:

SINCE MOVEMENT OF THE CD MECHANISM AND THE SENSITIVE CIRCUITY MAY CAUSE INTERFERENCE TO THE
RADIO TUNER NEARBY, SWITCH THIS UNIT OFF WHILE OPERATING OTHER

RADIO DEVICES.

PRECAUTIONS FOR USE
INSTALLATION

• UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.

• DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAIN VOLTAGE AND BEFORE ALL OTHER

CONNECTIONS HAVE BEEN MADE.

• DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS AROUND

THE UNIT FOR VENTILATION.

QUICK GUIDE CONNECTION

PLEASE FOLLOW THE FOLLOWING STEPS AND PROCEDURES TO SET UP YOUR MUSIC TOWER

I) MAIN UNIT + SUN-WOOFER CONNECTION

1) PLACE THE MAIN UNIT VERTICALLY DOWN TO THE SUB-WOOFER TOP AS SHOW ON PICTURE

2) PULL THE MAUN UNIT BACKWARD UNIT THE BRACKET HOOK UP & TIGHTLY AS SHOW ON PICTURE .

3) TRY TO LIFT UP THE WHOLE SYSTEM AND CHECK WHETHER THE MAIN UNIT & SUB-WOOFER ARE BEING

COMBINED TIGHTLY.

E-3

II) WIRE CONNECTION

1) CONNECT THE END OF THE SPEAKER CABLE

TO THE SPEAKER OUT TERMINAL (RED & WHITE HEAD)
(25) AT THE BACK OF MAIN UNIT, ANOTHER
TERMINAL CONNECT TO THE SPEAKER CLIP OF THE
SPEAKER BOX BACK SIDE(RED COLOR OF SPEAKER
CABLE TO RED COLOR OF SPEAKER CLIP)

2) CONNECT ONE END OF THE RCA CABLE (YELLOW

HEAD)
TO THE SUB-WOOFER OUT JACK (27) AT THE BACK OF
MAIN UNIT TO THE SUB-WOOFER IN JACK (31) AT THE
BACK OF THE SUB-WOOFER

3) CONNECT THE 75 OHM ANTENNA JACK(26) VIA A 75

OHM
CABLE(NOT PROVIDED) TO GET THE FM RECEPTION

III) POWER SUPPLY

CONNECT THE AC POWER CORD FROM THE MAIN UNIT(28) AND AC POWER CORD FROM SUB-WOOFER UNIT(30)TO
THE MAIN POWER SUPPLY FROM YOUR HOME AREA. TURN ON THE ON/OFF BUTTON AT MAIN UNIT (15) AND POWER
ON THE SUB-WOOFER (14) RESPECTIVELY. IF THE LCD DISPLAY (2) AND THE POWER LED (14) IS LIGHT UP WITH
BLUE LIHGT. IT MEANS THE SYSTEM IS NOW READY TO PLAY THE MUSIC.

SETTING THE CLOCK

1. SET UNIT IN STANDBY MODE.

2. PRESS THE “MEM/CLK-ADJ” BUTTON (17) ONCE, THE LCD DISPLAY (2) WILL SHOW “ 24 HR “. PRESS SKIP OR

SKIP BUTTON (10) TO SELECT THE APPROPIATE AREA HOUR FORMAT(12HR/24HR). PRESS “MEM/CLK-ADJ”
BUTTON (17) AGAIN TO CONFIRM.

3. THEN FIRST DIGIT OF “0:00” ON DISPLAY(2)(IF SELECT 24HS MODE) IS FLASHING. PRESS SKIP OR SKIP

BUTTON (10) TO SET THE CORRECT HOUR. PRESS ”MEM/CLK-ADJ” BUTTON (17) TO STORE THE CORRECT
HOUR.

4. THE THIRD & FOURTH DIGIT OF “0:00” IS FLASHING, PRESS THE SKIP OR SKIP BUTTON (10) TO SET THE

CORRECT MINUTES. THEN PRESS “MEM/CLK-ADJ” (17) TO STORE THE CORRECT MINUTE.

 THE PRE-SET TIME WILL BE RE-SET COMPLETELY IF DIS-CONNECTING THE MAIN POWER SUPPLY.

YOU ARE RECOMMENDED TO SWITCH THE SYSTEM INTO STANDBY MODE FOR CONVENIENCE
USAGE.

LISTENING TO RADIO

MANUAL TUNING

1. PRESS FUNCTION BUTTON (16) TO SELECT “ TUNER ” MODE.

2. TUEN TO THE DESIRE STATION BY PRESSING THE SKIP/TUNE OR SKIP/TUNE

3. ADJUST THE MAIN VOLUME CONTROL (3) AND SUB-WOOFER VOLUME (29) TO THE DESIRED VOLUME AND BASS

EFFECT LEVEL.

AUTO TUNING

1. PRESS FUNCTION BUTTON (16) TO SELECT “ TUNER ” MODE.

2. PRESS AND HOLD THE SKIP/TUNE OR SKIP/TUNE

RELEASE.

3. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP UNTIL A RADIO STATION IS REACHED.

4. REPEAT STEP 3 & 4 UNTIL THE DESIRED RADIO STATION IS BEING REACHED.

5. ADJUST THE MAIN VOLUME CONTROL (3) AND SUB-WOOFER VOLUME (29) TO THE DESIRED VOLUME AND BASS

EFFECT LEVEL.

BUTTON (10) FOR 1-2 SECONDS AND THEN

BUTTON (10).

E-4