Legrand PW1240 User Manual
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
1. INTRODUCTION
The 240 Watt Power Supply Kit (P/N PW1240) is a modular, scalable power solution that facilitates
organized cable management and improved space efficiency within an On-Q/Legrand enclosure.
2. DESCRIPTION
The kit consists of four 24 VDC, 2.5 A, 60 W power supplies, two standard On-Q half-width, tab &
plunger mounting brackets, a custom power strip, and four 12" velcro straps to secure the power
supplies (see Figure 1). On-Q/Legrand also offers a 120 Watt kit with two 24 VDC, 2.5 A, 60 W power
supplies (P/N PW1120 -- see Installation/Instruction sheet IS-0381).
3. INSTALLATION
A. INSTALL BRACKETS INTO ENCLOSURE
1. Choose a location within the enclosure that will
provide enough distance for both the custom power
strip and the power supply cables to be adequately
routed (see Figure 2).
IMPORTANT: THE SOCKET-OUTLET MUST BE
INSTALLED NEAR THE EQUIPMENT AND MUST
BE EASILY ACCESSIBLE.
INSTRUCTION / INSTALLATION SHEET
240 Watt Power Supply Kit
IS-0382 Rev. O
B. INSTALL POWER SUPPLIES INTO BRACKET
Refer to Figure 5
1. Slide the first power supply into the bracket. The
power supply should be completely inside the bracket
(behind the lower lip).
2. Slide the second power supply on top of the bracket.
The power supply should fit tightly between the upper
lip of the bracket and the enclosure. Repeat this for
the third and fourth power supplies.
3. Align the four plugs on the power strip with the
recepticle on each power supply and push until tight..
4. Loosely secure the power supplies to the bracket with
the included 12" velcro straps. When the power
supplies and power strip are connected and
positioned correctly, and the main power cord from
the strip reaches the receptical without any kind of
stretching, pull the velcro straps tight to secure the
assembly then plug the strip's cord into the receptical.
Figure 1
Figure 2
2. Align tabs on the mounting bracket with slots in the
enclosure (see Figure 3).
3. Insert tabs by
angling module
away from the
back of
enclosure.
4. Making sure the plunger is
pulled out, push the
bracket toward the enclosure, aligning the plunger
hole on the bracket with the corresponding hole on
the enclosure.
5. Push plunger in to lock
the bracket in place
(see Figure 4). Pull on
bracket to be sure it is
correctly locked into the
enclosure.Repeat to add the
second bracket above or below the first. Allow
enough room between the two brackets for one
power supply to fit in tightly.
©Copyright 2008 by On-Q/Legrand All Rights Reserved. Page 1 of 2
0.
Figure 3
Figure 4
Figure 5
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
4. EXAMPLE
Figure 6 shows the 240 Watt Power Supply Kit used to support a lyriQ™ High Performance Keypad application.
INSTRUCTION / INSTALLATION SHEET
240 Watt Power Supply Kit
IS-0382 Rev. O
Figure 6
©Copyright 2008 by On-Q/Legrand All Rights Reserved. Page 2 of 2
Loading...