Legrand PW1120 User Manual

301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com

1. INTRODUCTION

The 120 Watt Power Supply Kit (P/N PW1120) is a modular, scalable power solution that facilitates organized cable management and improved space efficiency within an OnQ/Legrand enclosure.

2. DESCRIPTION

The kit consists of two 24 VDC, 2.5 A, 60 W power supplies, a standard On-Q half-width, tab & plunger mounting bracket, a custom power strip, and two 12" velcro straps to secure the power supplies (see Figure 1). On-Q/Legrand also offers a 240 Watt kit with four 24 VDC, 2.5 A, 60 W power supplies (P/N PW1240 -- see Installation/Instruction sheet IS-0382).

3. INSTALLATION

A. INSTALL BRACKET INTO ENCLOSURE

1. Choose a location within the enclosure that will provide enough distance for both the custom power strip and the power supply cables to be adequately routed (see Figure 2).

IMPORTANT: THE SOCKET-OUTLET MUST BE INSTALLED NEAR THE EQUIPMENT AND MUST BE EASILY ACCESSIBLE.

INSTRUCTION / INSTALLATION SHEET 120 Watt Power Supply Kit

IS-0381 Rev. O

5. Push plunger in to lock the bracket in place (see Figure 4). Pull on bracket to be sure it is correctly locked into the enclosure..

Figure 1

Figure 2

2. Align tabs on the mounting bracket with slots in the enclosure (see Figure 3).

3. Insert tabs by angling module away from the back of enclosure.

Figure 3

4. Making sure the plunger is pulled out, push the bracket toward the enclosure, aligning the plunger hole on the bracket with the corresponding hole on the enclosure.

Figure 4

B. INSTALL POWER SUPPLIES INTO BRACKET

Refer to Figure 5

1. Slide the first power supply into the bracket. The power supply should be completely inside the bracket (behind the lower lip).

2. Slide the second power supply on top of the bracket. The power supply should fit tightly between the upper lip of the bracket and the enclosure.

3. Loosely secure the power supplies to the bracket with the included 12" velcro straps.

4. Align the two plugs on the power strip with the recepticle on each power supply and push until tight.

5. When the power supplies and power strip are connected and positioned correctly, and the main power cord from the strip reaches the receptical without any kind of stretching, pull the velcro straps tight to secure the assembly then plug the strip's cord into the receptical.

Figure 5

301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com

4. EXAMPLE

Figure 6 shows the 120 Watt Power Supply Kit used to support a lyriQ™ High Performance Keypad application.

INSTRUCTION / INSTALLATION SHEET 120 Watt Power Supply Kit

IS-0381 Rev. O

Figure 6