Legrand OR-HDJ5E-00 User Manual
125 EUGENE O'NEILL DRIVE
R
NEW LONDON, CT 06320
TEL: 860-445-3800
FAX: 860-405-2990
WWW.ORTRONICS.COM
TITLE:
HDJ PANEL INSTALLATION INSTRUCTIONS
HIGH DENSITYJACK INSTALLATION
JACK
PANEL
SLIDE LOCK
PULL BACK SLIDE LOCK TO STOP. THEN INSERT JACK INTO
PANEL (JACK WILL GO IN ONE WAY ONLY WITH SLIDE
LOCK UP).
ONCE JACK SHOULDERS COME
INTO CONTACT WITH BACKSIDE
OF PANEL, PRESS DOWNWARD.
PUSH ON SLIDE LOCK UNTIL THE FRONT IS FLUSH
WITH THE JACK FACE.
LABEL BEZEL INSTALLATION
PUSH ON LABEL BEZEL SO THAT
THE TWO BOSSES ON THE BACK LINE
UP WITH TWO JACK ICON POCKETS, THEN
PRESS INTO PLACE.
LABEL BEZEL
INSTRUCTION SHEET #:
71601790 01 04319
REV:
ECN #:
SHEET:
1 OF 2
DWN BY:
RWS
DATE:
11/17/11
GL
JACK ICON POCKET
JACK ICON POCKET
11/21/12
A.M.
11/21/12
125 EUGENE O'NEILL DRIVE
R
NEW LONDON, CT 06320
TEL: 860-445-3800
FAX: 860-405-2990
WWW.ORTRONICS.COM
TITLE:
HDJ PANEL INSTALLATION INSTRUCTIONS
SIMULATED RACK
SECTION
PANEL
SCREWS
ATTACH PANEL TO RACK WITH
SUPPLIED SCREWS.
PANEL MOUNTING INSTALLATION
WITH NUTS PROVIDED ATTACH WIRE
MANAGEMENT BAR TO PANEL BRACKETS.
TIGHTEN NUTS.
NUT
PANEL
BRACKET
PANEL
SCREWS
WIRE
MANAGEMENT BAR
CABLE MANAGEMENT INSTRUCTIONS (TOP VIEW)
HOOK LOOP TIES
WIRE
MANAGEMENT BAR
BEND
RADIUS*
* THE MINIMUM CABLE BEND RADIUS IS 4 TIMES THE OUTSIDE CABLE DIAMETER.
HOOK LOOP TIE WRAPS SHOULD BE USED TO ATTACH THE CABLES TO THE WIRE
MANAGEMENT BAR. THE CABLE AT THE EDGE OF THE PATCH PANEL SHOULD BE
ATTACHED TO THE CABLE WHICH HAS ALREADY BEEN TIE WRAPPED TO THE WIRE
MANAGEMENT BAR.
INSTRUCTION SHEET #:
71601790 01 04319
REV:
ECN #:
SHEET:
PG 2 OF 2
Loading...