La Crosse Technology WT-3165 User Manual

WT-3165 La Crosse Technology

Radio Controlled Analog Clock

Quick set up instructions

Welcome to the world of radio controlled timekeeping technology. We hope you will
enjoy the convenience of never having to set your clock again and the confidence of
always knowing the exact time

• Insert 1 fresh AA, LR6 1.5 volt ALKALINE battery according to the polarity marked

on the case.

• Press time zone button to select a time zone.

• Replace the battery compartment cover.

THAT’S IT! During the night your clock will automatically set itself.

COMPARTMENT

BATTERY

.

1

MANUAL TIME SET

BUTTON

BATTERY
COMPARTMENT

PACIFIC TIME

EASTERN TIME

MOUNTAIN TIME

CENTRAL TIME

For a better understanding of how and why your clock works please continue reading.

*DST (Daylight saving time) ON/OFF button

Pressing DST-ON/OFF button during DST the clock will switch to time without daylight saving.
Pressing it again DST will be activated again. In areas where no DST is used y ou may
deactivate DST by pressing the DST-OFF switch.

NOTHING IS MORE PRECISELY MEASURED THAN TIME!

And nothing keeps track of time more precisely and trouble free than La Crosse

Technology radio controlled clocks.
Since the beginning of time, man has been fascinated with the measurement of time and

has devised more accurate machines to trap and measure time. Today , time is precisely
measured in the United States by the most accurate clock in North America, the Atomic Clock
of the US National Institute of Standards and Technology, Time and Frequency Division in
Boulder, Colorado. A team of atomic physicists continually measures every second of every
day to an accuracy of ten billionths of a second per day. These physicists have created an
international standard, measuring a second as 9,192,631,770 vibrations of a Cesium 133 atom
in a vacuum. This atomic clock regulates the WWVB radio transmitter located in Fort Collins,
Colorado, where the exact time signal is continuously broadcast throughout the United States
at 60 kHz to take advantage of stable long wave radio paths found in that frequency range.
Radio waves at these low frequencies use the earth and the ionosphere as a wave-guide and
follow the curvature of the earth for long distances.

The built in antenna system will receive the WWVB signal anywhere in North America
within 2000 miles of Fort Collins where long-wave radio reception is undisturbed. A
microprocessor activates the receiver and processes the time signal from Fort Collins
overnight.

Through the radio signals, La Crosse Technology radio controlled clocks alw ays keep
precise time. The changeover from standard time to daylight saving time, and vice versa, takes
place automatically with the same precision.

ADDITIONAL DETAILS

To set up your clock simply install one fresh AA, LR6 ALKALINE battery. Due to the
nature of long wave radio signals it is normally not possible to receive a signal during the day
so it is best to install the battery late in the evening. Select your time zone by pressing one of
the four time zone buttons PT-Pacific Time, MT-Mountain Time, CT-Central Time, ET-Eastern
Time. The time zone buttons may be pressed any time after installing the batteries. If multiple
buttons are pressed the clock will set to the time zone selected last. If no time zone is selected
the clock will default to Pacific Time. Another time zone can be selected during or after the
clock has set itself. Your clock can only set itself to one of the four time zones stated above.
For time zones outside of PT, MT, CT or ET you must manually set the time using the Manual
Time set button on the back of the movement.

Once the battery is installed the clock will begin searching for a signal. For the initial
setting it is recommended to stand the clock in an upright position near a window. Within five

DST ON/OFF BUTTON*

2