La Crosse Technology WS-7208TWC User Manual

WS-7208TWC
Wireless 433 MHz
Weather Station
Instruction Manual
Topic Page
Quick Setup 3-5 Inventory of Contents 6-7 Detailed Setup Guide
Battery Installation 8 Setting the Time 9
Features
Minimum and Maximum Temperatures
Resetting Minimum and
Maximum Temperatures Adding additional remote temperature sensors (optional) Weather Forecast 14 Weather Icons 15-16
Tendency Arrow 17 Mounting 18-19 Troubleshooting 20-21 Maintenance and Care 22 Specifications 23-24 Warranty Information 25-28
10
11
12-13
2
QUICK SETUP
Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries.
1. Have the indoor temperature station
and remote temperature sensor 3 to 5 feet apart.
2. Batteries should be out of both units
for 10 minutes.
3. Place the batteries into the remote
temperature sensor first then into
the indoor temperature station. (All remote temperature sensors must be started before the indoor temperature station)
4. DO NOT PRESS ANY BUTTONS
FOR 10 MINUTES.
3
In this time the indoor temperature station and remote temperature sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures after the 10 minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 10 minutes you can place your remote temperature sensor outdoors and set your time.
The remote temperature sensor should be placed in a dry, shaded area. The remote temperature sensor has a range of 80 feet. Any walls that the signal will have to pass through will reduce distance. An outdoor wall or window will have 20 to 30 feet of resistance and an interior wall will have 10 to 20 feet of resistance.
4
Your distance plus resistance should not exceed 80 ft. in a straight line. NOTE: Fog and mist will not harm your remote temperature sensor but direct rain must be avoided.
To complete the set up of your indoor temperature station after the 10 minutes have passed please follow the steps in the detailed set up guide on page 8-9.
5
INVENTORY OF CONTENTS
1. The indoor weather station (Figure 1)
2. The remote temperature sensor (TX6U)
and mounting bracket. (Figure 2)
3. 3 each, 1/2” Philips screws.
4. One strip of double sided adhesive tape.
5. Instruction Manual and Warranty Card.
Figure 1
Figure 2
Holder
6
ADDITIONAL EQUIPMENT
(not included)
1. 1 Philips screwdriver.
2. 2 Fresh AA Alkaline batteries.
3. 2 Fresh AA Alkaline batteries
7
DETAILED SETUP GUIDE
Battery Installation
1. Install 2 AA
batteries in the
remote temperature
sensor. Make sure
they do not spring
free, or start-up
problems may occur.
2.
Install 2 AA
batteries in the
indoor weather
station. Do not
press any
buttons for at
least ten minutes.
8
Setting the time
1. Press and
hold the
“SET”
key for 4
seconds.
2. The hour
will flash.
3. Press and release the “+” key to
advance the hour.
4. Press and release the “SET” key.
5. The minute is flashing.
6. Press and release the “+” key to
advance the minutes.
7. Press and release the “SET” key to exit
programming.
9
Loading...
+ 19 hidden pages