Atomic Digital Wall Clock
Model: 513-1311OTN
DC: 102618
Full Manual and FAQS under the Support Tab at: bit.ly/513-1311otn
POWER UP
1.Insert 2 new “AAA” batteries into the outdoor sensor. Observe correct polarity. The red LED will flash when transmitting.
2.Insert 3 new “C” batteries (not included) into the clock. Observe the correct polarity.
3.Once the sensor is reading to your station, place sensor outside in a shaded location.
Watch sensor mounting video: http://bit.ly/TH_SensorMounting
AA A
AA A
D1: Transmission LED |
D5: “RESET” |
D2: Outdoor Temperature |
D6: °C/°F” button |
D3: Battery Compartment |
D7: Stand |
D4: Wall Mount Hole |
|
SETTINGS
•Hold the MODE/SET button to enter the settings menu.
•Press the + or – buttons to adjust the values.
•Press the MODE/SET button to confirm adjustment and move to the next item.
Settings menu order:
•Hour • Minutes • Seconds • Year • Month/Date (M/D or D/M)
•Month • Date • DST indicator
Note: Weekday will set automatically when Year, Month and Date are set.
12/24 HOUR TIME & TIME ZONE SELECTION
•Press the + 12/24 button to select 12 hour or 24 hour time.
•Hold the +12/24 button to select the time zone.
•Time zones:
P |
Pacific |
|
Mountain |
M |
|
C |
Central E |
E |
Eastern |
FAHRENHEIT | CELSIUS TEMPERATURE DISPLAY
•Press the - °C/°F button to change the temperature display from Fahrenheit to Celsius.
WWVB ATOMIC TIME 
IMPORTANT: When the clock is searching for the WWVB Atomic Time signal, the buttons will not work. To use the buttons simply hold the
-°C/°F button to stop the clock from searching. Buttons will now work.
•Hold the - °C/°F button to start or stop a manual search for the WWVB Atomic Time signal.
•WWVB Tower Icon will flash when searching.
•For information about WWVB Atomic Time visit: http://bit.ly/AtomicTime
Note: The atomic clock will search for 1 hour between midnight and 6am until the WWVB time signal is received. After reception, your clock will only search for the atomic signal after midnight.
TIME ALARM
1.Press the MODE/SET button to view alarm time. The letters AL will replace the seconds.
2.Hold the MODE/SET button and the Hour will flash.
3.Use the + or - buttons to adjust the hour.
4.Press the MODE/SET button to confirm and move to the minutes. Minutes will flash.
5.Use the + or - buttons to adjust the minutes.
6.Press the MODE/SET button to confirm and exit.
DEACTIVATE/ACTIVATE ALARM
•Press the AL ON/OFF button to activate the alarm.
•The bell icon will appears when alarm is active.
•Press the ALARM ON/OFF button to deactivate the alarm.
•The bell icon will disappear.
SNOOZE
•When the alarm sounds, press the SNOOZE button to trigger snooze alarm for 5 minutes.
•The snooze icon Zz will flash above the time.
•The snooze function can be repeated up to seven times.
Page | 3 |
Page | 4 |
Loading...