Karcher T50 User Manual
Hard Surface Cleaner
Lavador de superficies duras
Nettoyeur de surface dure
T 50
T-Racer
English ................. 2
Español ................ 6
Français.............. 10
5.961669.0 (02/06)
T 50 OVERVIEW
Item Description
1 Housing
2 Handle
A Union nut
2
Kärcher Support USA
Call: 1-800-537-4129 for help
or visit our website: www.karcher-usa.com/home
Kärcher Customer Service CDN
Call: 1-800-465-4980 for help
or visit our website: www.karcher-canada.com
Kärcher Support Mexico
Call: 01-800-024-13-13 for help
or visit our website: www.karcher.com.mx
IMPORTANT SAFETY INSTRUCTIONS
WARNING When using this
product basic precautions should
always be followed, including the
following:
Read all the instructions before
using the product.
Please observe the safety instructions of your pressure washer.
The T-Racer must not be used by
children.
Only trigger the gun of the pressure
washer if the T-Racer is located on
the surface to be cleaned.
Keep all persons/animals clear of
the immediate vicinity of the
cleaning head.
Keep hands away from moving
parts.
Turn off the pressure washer when
examining or changing the T-Racer
and after the completion of the
cleaning operation.
Maximum water temperature
allowed is 140°F/ 60 °C. Please
follow the instructions for your
pressure washer.
CAUTION!
Do not use on windows.
The T-Racer is not suited for
scouring or scrubbing!
Do not run over freestanding
corners!
For the optimum setting, test the
TRacer in an inconspicuous area.
Never operate in the same area
for more than 2 seconds, damage
may occur.
INTENDED USE
Use on horizontal surfaces like drive-
ways, patios, side walks, etc.
Use on vertical surfaces like brick
walls, hardiplank, stucco and other
siding. (Always test in inconspicuous
area first.)
The T50 has not been designed for
commercial use.
3
SAVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
4
Step 1
1. Press the handle into the bayonet catch of the high-pressure gun.
2. Turn it by 90° until it locks into place.
3. Turn union nut clockwise until tight.
Step 2
4. Press the housing into the bayonet catch of handle.
5. Turn it by 90° until it locks into place.
6. Turn union nut clockwise until tight.
APPLICATION DIRECTIONS
Please Note:
Do not run over free-standing corners!
Never operate in the same area for more than
2 seconds, damage may occur.
Do not use on windows.
Cleaning of vertical surfaces:
Always hold Trigger Gun and T-Racer with both hands.
Do not reach under the edge of the T-Racer while the device is in operation.
5
REPLACEMENT OF THE NOZZLES
Note: The nozzles must be
removed for cleaning or for the
exchange of the nozzles.
1. Remove the clamp.
2. Pull out the old nozzle.
3. Insert the new nozzle.
4. Secure nozzle with clamp.
Loading...