Kyocera TASKalfa 552ci SERVICEBULLETIN 2LC 0056 C028 1

(Revised Issue 1) (Page.1/1)

Subject

DT-730 (-->) Support for TASKalfa 2550ci (New Screws)

Model l:

TASKalfa 5550ci, TASKalfa 4550ci, TASKalfa 3550ci,
TASKalfa 3050ci, TASKalfa 7550ci, TASKalfa 6550ci,
TASKalfa 5500i, TASKalfa 4500i, TASKalfa 3500i,
TASKalfa 8000i, TASKalfa 6500i, (-->)TASKalfa 2550ci

KMC’s Classification Entire Stock Rework In-Field modification at next visit

In-Field modification by case No modification necessary

Field Measure: Please note that the screws are separately required to use the DT-730 with (-->) TASKalfa

2550ci if they are not bundled.

Serial Nos. of the Affected Machines: (-->) From the February 2012 production (Lot No.: 22****)
Added

LOT No.
First 2 digits indicate year and month
For example
18 = August 2011 production

Service Bulletin Ref. No. 2LC-0056 (C028)

[Service information] <Date> August 18, 2012

This time, the description with (-->) was revised from the previous information.
<Number of changes: 6> The description of the new development model was revised to the TASKalfa 2550ci.

“Planned in February 2012” was changed to “February 2012 production” in [Serial Nos. of Affected Machines].

Topic

Two pieces of the screw were added as follows to install the DT-730 to the (-->) TASKalfa 2550ci.
Please note this when using the DT-730 with (-->) TASKalfa 2550ci.

Content of Changes

- 7BB607410H: +TP-CUP M SCREW 4x10 R: 2 pcs.

- Distinction: Lot No. (22**** and after) indicated on the outer case barcode label

<Outer case barcode label>

KYOCERA Document Solutions Europe

Technical Customer Service Division (TCSD)