Thank you for purchasing the Korg AW-LT100V Clip-on Tuner. To
help you get the most out of your new instrument, please read
this manual carefully.
Merci d’avoir choisi la Clip-on Tuner AW-LT100V de Korg. An de
pouvoir exploiter au mieux toutes les possibilités offertes par
l’instrument, veuillez lire attentivement ce manuel.
Vielen Dank, dass Sie sich für einen AW-LT100V Clip-on Tuner
von Korg entschieden haben. Bitte lesen Sie sich diese Anleitung
vollstädig durch, um bei der Bedienung alles richtig zu machen.
Gracias por comprar el anador para enchufar AW-LT100V Clipon Tuner de Korg. Por favor, lea este manual atentamente y
guárdelo para futuras consultas.
Using the unit in the following locations can result in a malfunction.
• In direct sunlight
• Locations of extreme temperature or humidity
• Excessively dusty or dirty locations
• Locations of excessive vibration
• Close to magnetic elds
Power supply
Be sure to turn o the power when the unit is not in use. Remove the battery in
order to prevent it from leaking when the unit is not in use for extended periods.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.
Handling
To avoid breakage, do not apply excessive force to the switches or controls.
Care
If the exterior becomes dirty, wipe it with a clean, dry cloth. Do not use liquid
cleaners such as benzene or thinner, or cleaning compounds or ammable polishes.
Keep this manual
After reading this manual, please keep it for later reference.
Keeping foreign matter out of your equipment
Never set any container with liquid in it near this equipment. If liquid gets into
the equipment, it could cause a breakdown, re, or electrical shock. Be careful
not to let metal objects get into the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
• Consult the dealer or an experienced radio/TV technician for help.
If items such as cables are included with this equipment, you must use those
included items.
Unauthorized changes or modification to this system can void the user’s
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAN ICES-3 B / NMB-3 B.
This product has been manufactured according to strict specifications and
voltage requirements that are applicable in the country in which it is intended
that this product should be used. If you have purchased this product via the
internet, through mail order, and/or via a telephone sale, you must verify that
this product is intended to be used in the country in which you reside.
WARNING: Use of this product in any country other than that for which it is
intended could be dangerous and could invalidate the manufacturer’s or
distributor’s warranty.
Please also retain your receipt as proof of purchase otherwise your product
may be disqualied from the manufacturer’s or distributor’s warranty.
* All product names and company names are the trademarks or registered
THE FCC REGULATION WARNING (for USA)
which the receiver is connected.
Notice regarding disposal (EU only)
If this symbol is shown on the product, manual, battery, or package, you
must dispose of it in the correct manner to avoid harm to human health
or damage to the environment. Contact your local administrative body
for details on the correct disposal method. If the battery contains heavy
metals in excess of the regulated amount, a chemical symbol is displayed
below the symbol on the battery or battery package.
IMPORTANT NOTICE TO CONSUMERS
trademarks of their respective owners.
- 1 -
Parts of the AW-LT100V
4th string
°
10°
a. Left shuttle switchb. Right shuttle switch
c. Battery compartment (Rear)d. Tuner mode indicator
e. Pure major thirdf. Pure minor third
g. Reference pitch indicatorh. Meter
i. Note name indicatorj. PURE 5TH indicator
k. Battery indicator
Installing the battery
When the battery becomes depleted, a
battery symbol () will appear on the
display. Immediately replace the battery
with a new one.
Open the battery compartment cover on
1.
the rear of the tuner in the direction of
the arrow.
Insert the battery, making sure to observe
2.
the correct polarity, and then close the
cov er.
Attaching to the instrument and range of motion
The AW-LT100V tunes by picking up the
vibrations of the instrument. Therefore, attach
the AW-LT100V to the headstock of your
instrument in order to tune it. Additionally, the
AW-LT100V can be freely moved so that the
display is easy to read.
The AW-LT100V may be damaged if you
apply excessive force within its range of
motion, or attempt to move it beyond its
intended range of motion.
Please carefully attach the AW-LT100V to
your instrument. Leaving the AW-LT100V
attached for a long time may damage or
mark the instrument's surface.
Depending on various factors such as age-
related change or the surface nish, there is
a possibility that your instrument may be damaged by attaching this
product.
100°
Tuning
Tuning procedure
Turn the left shuttle switch upward. Each time you turn the shuttle
1.
switch, the AW-LT100V will be turned on or o.
If the power is left on for approximately 20 minutes without any user
input, it will turn o automatically (Auto power-o function).
If necessary, change the reference pitch (calibration) and tuner mode.
2.
The procedure with the tuner mode set to chromatic (factory default; no
mode indicator,) is described below.
Play a single note on your instrument.
3.
The note name closest to the detected
pitch appears in the note name
indicator. Tune your instrument until
the correct note name appears in the
display and the meter segments at the
center (
An indicator toward the right will light
) light up.
Meter indications
when correctly tuned
340°
up if the pitch is too high, and an indicator toward the left will
light up if the pitch is too low. If you want to tune to a pure major
third or pure minor third above a certain note, adjust the pitch to
the pure major or minor third marks on the meter. For example
if you want to tune to a pure major third above A, make the note
name indicator read C#, and tune so that the meter indicates the
left
. Alternatively, if you want to tune to a pure minor third
above A, make the note name indicator read C, and tune so that
the meter indicates the right
Even if the pitch is within the range of detection, it may not
be possible to detect the pitch of an instrumental sound that
contains large numbers of overtones or a sound that has a rapid
decay.
The meter may respond to vibrations it picks up from the
environment; however, this will not affect tuning of the
instrument.
.
Setting the tuner mode (*M)
Each time you turn the left shuttle switch downward, the tuner mode
changes, with the current mode shown by the tuner mode indicator.
Chromatic (no indicator) ¬ Violin (
Chromatic ...
In the violin and viola modes, the string number closest
to the detected pitch appears to the left of the note name
indicator.
Note name indicators for violin mode : 4G, 3D, 2A, 1E
Note name indicators for viola mode : 4C, 3G, 2D, 1A
In the violin and viola modes,
lower-left corner of the display to indicate the pure fth
temperament relative to the A string.
appears in the
Reference pitch settings (calibration) (*M)
Each time you turn the right shuttle switch upward (or downward),
the reference pitch (calibration value) increases (or decreases) in 1 Hz
10
steps.
Backlight
After turning the left shuttle switch upward to turn on the AWLT100V, you can change the brightness of the display by keeping the
left shuttle switch turned upward for approximately 2 seconds.
Auto : The backlight will light brightly when sound is inputted or
when a shuttle switch is operated. When there has been no sound
input or shuttle switch operation for approximately three seconds
after the power has been turned on, the backlight will turn off in
order to prevent the battery from being depleted.
Soft : The backlight will light at a lower level of brightness in order to
prevent the battery from being depleted.
L’utilisation de cet instrument dans les endroits suivants peut en entraîner le mauvais fonctionnement.
• En plein soleil.
• Endroits très chauds ou très humides.
• Endroits sales ou fort poussiéreux.
• Endroits soumis à de fortes vibrations.
• A proximité de champs magnétiques.
Alimentation
Lorsque vous n’utilisez pas l’appareil, n’oubliez pas de le mettre hors tension. Retirez les piles pour éviter toute fuite lorsque l’appareil ne sera pas utilisé pendant
de longues périodes de temps.
Interférences avec d’autres appareils électriques
Les postes de radio et de télévision situés à proximité peuvent par conséquent
sourir d’interférences à la réception. Veuillez dès lors faire fonctionner cet appareil à une distance raisonnable de postes de radio et de télévision.
Maniement
Pour éviter de les endommager, manipulez les commandes et les boutons de cet
instrument avec soin.
Entretien
Lorsque l’instrument se salit, nettoyez-le avec un chion propre et sec. Ne vous
servez pas d’agents de nettoyage liquides tels que du benzène ou du diluant,
voire des produits inammables.
Conservez ce manuel
Après avoir lu ce manuel, veuillez le conserver soigneusement pour toute référence ultérieure.
Evitez toute intrusion d’objets ou de liquide
Ne placez jamais de récipient contenant du liquide près de l’instrument. Si le
liquide se renverse ou coule, il risque de provoquer des dommages, un court-circuit ou une électrocution. Veillez à ne pas laisser tomber des objets métalliques
dans le boîtier (trombones, par ex.).
Note concernant les dispositions
Si ce symbole apparait sur le produit, le manuel, les piles ou les packs de
piles, cela signi e que vous devez le recycler d’une manière correcte a
n de prévenir les dommages pour la santé humaine et les dommages
potentiels pour l’environnement. Contactez votre administration locale
pour de plus amples renseignements concernant la bonne méthode de
recyclage. Si la pile contient des métaux lourds au-delà du seuil réglementé, un symbole chimique est a ché en dessous du symbole de la
poubelle barrée d’une croix sur la pile ou le pack de piles.
REMARQUE IMPORTANTE POUR LES CLIENTS
Ce produit a été fabriqué suivant des spéci cations sévères et des besoins en
tension applicables dans le pays où ce produit doit être utilisé. Si vous avez
acheté ce produit via l’internet, par vente par correspondance ou/et vente par
téléphone, vous devez véri er que ce produit est bien utilisable dans le pays
où vous résidez.
ATTENTION: L’utilisation de ce produit dans un pays autre que celui pour
lequel il a été conçu peut être dangereuse et annulera la garantie du fabricant
ou du distributeur. Conservez bien votre récépissé qui est la preuve de votre
achat, faute de quoi votre produit risque de ne plus être couvert par la garantie du fabricant ou du distributeur.
* Tous les noms de produits et de sociétés sont des marques commerciales ou
déposées de leur détenteur respectif.
(Seulement EU)
- 3 -
Loading...
+ 5 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.