KONICA MINOLTA QMS magic 2 plus Repacking Guide

magicolor magicolor

2+ and

2 DeskLaser (Duplex Model) Repacking Instructions

1760268-001B

Trademarks

The following are trademarks or registered t rademarks of their respec tive owners. Other produc t names mentioned in this manua l may also be trademar ks or registe red tradema rks of their respective owners. Registered trademarks are registered in the United States Patent and Trademark Office; some trademarks may also be registered in othe r co untr ie s. MINO LTA-QMS, Crown, magicolor, the MINOLTA-QMS logo, and the Crown logo are registered trademarks of MINOLTA-QMS, Inc.

This manual is Copyrighted © 2000 by MINOLTA-QMS, Inc., One Magnum Pass, Mobile, AL 3661 8. All Rights Reser ved. This ma nual may not be copied in w hole or in part, nor transferred to any other med ia o r language, without the express wr itten per miss ion of MINOLTA-QMS, Inc.

Introduction

If you need to relocate or ship your printer after it’s been installed, you must follow the procedures in this chapter to prevent damage to the printer and to keep your warranty valid.

! Caution: We cannot be held responsible for damage to your printer during shipment

that results from the improper packaging of your printer. You must use the instructions given in this section before repacking the printer in its original shipping carton with the original packing materials.

If you need replacement packaging, in the US call MINOLT A-QMS at 1 ( 334) 633 -4300 extension 2530 and request catalog number 2600439-201.

If you need to return the printer for service, contact your local vendor for an RMA (Return Merchandise Authorization) number before shipping the printer . For a listing of support telephone numbers, refer to appendix A in your printer documentation.

What's Involved?

Repacking your printer for shipment involves the following steps. Each is described in more detail in the following sections.

1 Remove the cables and media cassette(s). 2 Remove the toner cartridges. 3 Prepare the fuser unit for shipment. 4 Change the waste toner pack. 5 Pack the printer for shipment.

»Note: To avoid toner contamination during shipment, leave the OPC belt cartridge

installed.

magicolor

2+/

magicolor

2 DeskLaser Duplex Repacking

Remove Cables and Cassette(s)

» Note: If you’re returning the printer for service, you don’t need to return the power

cable, interface cables, or media cassette(s).

1 Turn off the printer. 2 Remove the power cable and all interface cables.

» Note: In compliance with UL guidelines, “The appliance inlet is considered to be

the main disconnect device.”

3 Remove the media cassette(s) from the printer.

Remove the Toner Cartridges

1 Open the printer’s front cover. 2 Remove the four toner cartridges, attach the protective shields over their

magnetic rollers, and repackage them in their original packaging.

Prepare the Fuser Unit

" WARNING! The fuser unit can become extremely hot and cause severe burns. Make

sure the unit is cool before handling it. ACHTUNG! Die Fixiereinheit kann sehr heiß werden, so daß Verbrennungsgefahr

besteht. Bitte lassen Sie die Fixiereinheit einige Zeit abkühlen, bevor Sie diese berühren.

magicolor

2+/

magicolor

2 DeskLaser Duplex Repacking2

+ 8 hidden pages