KONICA MINOLTA QMS magic 2 Instruction

QMS® magicolor® 2 Print System

Special Repacking Instructions

Introduction

These repacking instructions are designed for QMS damaged in transit and being returned to QMS, Inc.

» Note:

It’s very important that you repack the print system in its original shipping carton before using the instructions in this document. This is necessary so QMS can determine the cause of the shipping carton failure and remedy this problem in future shipments. (Refer to chapter 9, “Repacking the Printer,” in the

System Operation

carton.)

Procedure

Once you’ve repacked the printer in its original shipping carton, use these instructions to pack it in its special overpack carton.

1 Assemble the overpack carton, closing and

taping the bottom flaps. 2 Set the carton on a flat surface. 3 Place at least 4" of polystyrene packing

material (“peanuts”) on the bottom of the

carton.

magicolor

manual for instructions on repacking the printer in its original shipping

2 Print Systems

QMS magicolor 2 Print

If you don’t have any polystyrene packing

material, you can purchase some from a local mailing or shipping company.

4 Set the printer, in its original shipping carton, on the polystyrene packing

material in the center of the overpack carton. 5 Fill the rest of the overpack carton with packing material, surrounding the

original shipping carton on all sides and the top. 6 Close and tape the top flaps of the overpack carton. 7 Attach the shipping symbol labels to the top-left corner of all fou r sides of the

overpack carton. 8 Complete and attach the shipping label to one side of the overpack carton. 9 Send the carton back to QMS, Inc., One Magnum Pass, Mobile, AL 36618.

QMS and magicolor are registered trademarks of QMS, Inc. All other trademarks of the property

P/N 1760198-001A