Page 1
WATER BOILER
KH 1134
WATER BOILER
Operating instructions
Page 2
KH 1134
q
o
w
i
u
y
e
r
t
o
Page 3
6
KOMPERNASS GMBH · BURGSTRASSE 21 · D-44867 BOCHUM
www.kompernass.com
ID-Nr.: KH1134-11/07-V1
Page 4
CONTENT PAGE
Intended Use 4
Technical Data 4
Operating elements 4
Safety Instructions 4
Starting Up the Device 5
Boiling Water 5
Temperature regulator in the boiling range 5
Temperature regulator in the keep warm range 5
Cleaning and Care 6
Storage 6
Disposal 7
Warranty & Service 7
Importer 7
Read the operating instructions carefully before using the appliance for the first time and preserve this booklet for later reference. Pass the manual on to whomsoever might acquire the scale at a later date.
- 3 -
Page 5
WATER BOILER
Safety Instructions
Intended Use
This device is intended for heating water for household use. It is not intended for use with other liquids
or for commercial use.
Technical Data
Voltage: 220 - 240 V ~/ 50 Hz
Power consumption: 2500 - 3000 W
In older electrical installations, the building
fuse (12A) may be triggered due to the high
power consumption.
Operating elements
Lid
q
Unlocking button
w
ON/OFF switch
e
Operating light
r
Base
t
Temperature control
y
Kettle
u
Level indicator
i
Spout screen
o
To avoid the risk of fatalities from electric
shocks:
• Make certain that the base twith the electrical
connections never comes into contact with
water! Let the base
before using if it has accidentally become wet.
• Only use the hot water kettle with the supplied
base
.
t
• Make sure that the power cord never becomes
wet or damp during operation. Lay the cord such
that it cannot be pinched or otherwise
damaged.
• Arrange for defective power plugs and/or
cables to be replaced as soon as possible by a
qualified technician or by our Customer Service
Department to avoid the risk of injury.
• Always pull the plug out of the power socket
after use. Switching off the device is not sufficient
because the device receives power as long as
the power plug is connected to the socket.
To prevent the risk of fire or injury:
• Always heat water with a closed lid q, otherwise the automatic cut-out mechanism doesn’t
work. Boiling water can then spray out over the
edge.
• Hot steam clouds may be released. The kettle
is also very hot during operation. Wear oven
mits.
• Make certain that the device rests firmly and vertically before switching it on. Boiling water can
cause an unstabile kettle to fall over.
• Do not allow individuals (including children) to
use the appliance whose physical, sensorial or
mental abilities or lack of experience and knowledge hinder their safe usage of it if they have
not previously been supervised or instructed in its
correct usage.
• Tell children about the appliance and its potential dangers so that they do not play with it.
become completely dry
t
u
- 4 -
Page 6
Starting Up the Device
MIN
MAX
• Before starting up the device, make certain that...
– the device, plug and power cable are in good
working order and...
– all packaging materials have been removed
from the device.
• Fill the device with water up to the MAX mark
and let it come to a full boil once – as described
in the next section. Pour out this water.
Boiling Water
Danger! Never place the electrical base
near water – life-threatening danger!
You should only heat as much water as you need
directly. That helps you save electricity, water and
time:
• Lift away the kettle
• Open the lid
king button
• Hold the kettle
then will the level indicator
correctly indicate the water volume.
Fill the kettle u...
– at least to the MIN mark so that the device does
not overheat,
– no higher than the MAX mark so that no boiling
water spills out.
• First close the lid
• then place the kettle
straight on the base
• Set the desired water temperature using the
temperature control
To bring the water to a boil, you must set the
temperature controller
• Now insert the power plug into the power
socket ...
• and press the ON/OFF switch
snaps in.
q
w
for filling!
u
by pressing down on the unlok-
.
vertically while filling. Only
u
on the side
i
...
q
on the base tuntil it sits
u
.
t
.
y
to the MAX position.
y
down until it
e
• The operating light rindicates that the device is
now heating up.
e
g
n
a
r
m
r
a
w
p
e
e
k
Transition-
range
b
o
i
l
i
n
g
r
a
n
g
e
Temperature regulator in the boiling
range
• The devices switches off automatically and the
operating light
is at a full boil.
The ON/OFF switch
In order to keep the water warm after bringing it to
a boil, set the temperature regulator yin the keep
warm range.
Press the ON/OFF switch
goes out as soon as the water
r
springs out.
e
down, until it snaps in.
e
Temperature regulator in the keep
warm range
The left end of the keep warm range indicates the
lower temperature. The right end of the keep warm
range indicates the higher temperature.
(The water does not start boiling in the keep warm
range!).
• After reaching the desired temperature, the appliance switches off the heating process. The
ON/OFF switch
remain switched on.
and the operating lights
e
r
- 5 -
Page 7
Because the device is equipped with a heat
maintenance function, the device automatically
begins reheating as soon as the water temperature falls below the set temperature.
The appliance heats until the desired temperature is reached. Make sure that the appliance
does not automatically switch on to the keep
warm function. Therefore, do not leave the
appliance unsupervised!
• As soon as the kettle
, the ON/OFF switch ejumps out and the
t
operating lights
• In order to halt the heating process, push the
ON/OFF switch
light
goes out then as well.
r
Avoid setting the temperature regulator
the transition range, as the water can start boiling on account of varying filling levels.
Warning: Pull the power plug from the
socket before lifting the kettle
base
. This prevents any water
t
splashing out from contacting the electrical
connections in the base, which could cause
a short circuit.
For safety reasons, the lid should not be
opened while the water is boiling or is
very hot. Otherwise there is a risk of
injury.
is lifted from the base
u
switch off.
r
up again. The operating
e
from the
u
y
Never submerse any parts of the device in
water or other liquids! This can create the
risk of a life-threatening electrical shock if
residual liquid comes into contact with
powered components.
Before cleaning the device, ....
• First pull the power plug out of the power socket
and let the device cool completely.
• Clean the exterior surfaces and the power cord
with a slighly damp cloth. Always dry the device
well before using it again.
• Never use any cleansers, abbrasive substances
or solvents. These can damage the device.
In the event of calcium deposits
• Purchase a decalcifying agent suitable for use
in
with food containers from a household goods
stores (e.g. coffee machine decalcifier).
• You can use a suitable product from a
specialised dealer for the stainless steel
container bottom.
Removing / replacing the spout screen
• Open the lid completely.
• Press down on the edge of the spout screen from
above in order to remove it toward the inside.
• Clean the spout screen
moistened wash cloth.
• After cleaning, insert the screen from above and
press it firmly into place.
with a lightly
o
Cleaning and Care
Danger!: Do not open any part of the
housing. There are no operating elements
inside. An open housing can create the risk
of a life-threatening electrical shock.
Storage
Let the device cool completely before storing it.
• Wind the power cord around the holder on the
bottom of the device.
• Store the device in a dry place.
- 6 -
Page 8
Disposal
Do not dispose of the appliance in your
normal domestic waste.
Dispose of the appliance through an approved disposal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
Warranty & Service
The warranty for this appliance is for 3 years from
the date of purchase. The appliance has been
manu-factured with care and meticulously examined
before delivery. Please retain your receipt as proof
of purchase. In the case of a warranty claim, please
make contact by telephone with our service department. Only in this way can a post-free despatch for
your goods be assured.
The warranty covers only claims for material and
maufacturing defects, not for wearing parts or for
damage to fragile components. This product is for
private use only and is not intended for commercial
use.
The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service
branch. Your statutory rights are not restricted in
any way by this warranty.
DES Ltd
Units 14-15
Bilston Industrial Estate
Oxford Street
Bilston
WV14 7EG
Tel.: 0870/787-6177
Fax: 0870/787-6168
e-mail: support.uk@kompernass.com
Kompernass Service Ireland
c/o Irish Connection
41 Harbour view
Howth Co. Dublin
Tel: 087-99 62 077
Fax: 18398056
e-mail: support.ie@kompernass.com
Importer
KOMPERNASS GMBH
BURGSTRASSE 21
D-44867 BOCHUM
www.kompernass.com
- 7 -
Loading...