Kohler SSP-10, SG-210 Owner's Manual

SAFETY PRECAUTIONS AND INSTRUCTIONS

WARNING

Make sure that the voltage set is suitable for the instrument (the voltage is indicated next to the AC
power inlet).
When using electric products, always follow basic precautions, including the following:
1 Read all of these instructions before using the product.
2 To reduce the risk of injury, close supervision is necessary when the product is used near

children.

3 Do not use this product near water - for example, near a bathtub, washbowl, kitchen sink, in

a wet basement, near a swimming pool, or the like.

4 This product, either alone or in combination with an amplifier and headphones, or speakers

may be capable of producing sound levels that could cause permanent hearing loss Do not
operate for a long period of time at a high volume level, or at a level that is uncomfortable.
If you experience any hearing loss, or ringing in your ears, you should consult an
audiologist.

5 The product should be located so that its location, or position, does not interfere with proper

ventilation.

6 This product should only be located away from heat sources such as radiators, heat registers,

and other products that cause heat.

7 The product should be connected only to the type of power supply described in the operating

instructions, or as marked on the product.

8 This product may be equipped with a polarised plug. This is a safety feature. If you are

unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the plug.

9 The power-supply cord of the product should be unplugged from the outlet when left unused

for a long period of time When re-plugging unit, turn on the keyboard and leave on for 3-5
hours to recharge internal battery. The battery may need to be replaced after two or three
years of use.

10 Care should be taken so that objects do not fall, and liquids are not spilled, into the cabinet

through openings
11 The product should be serviced by qualified personnel when:
a The power-supply cord or the plug has been damaged; or
b Objects have fallen, or liquid has been spilled, into the product or
c The product has been exposed to rain or

d The product does not appear to operate normally, or exhibits a marked change in

performance, or
e The product has been dropped, or the cabinet damaged
12 Do not attempt to service the product beyond that described in the maintenance instructions.
All other servicing should be referred to qualified service personnel.

- 2 -

GROUNDING INSTRUCTIONS

This product must be grounded (earthed). If should malfunction or breakdown, grounding provides
a path of least resistance for electric current to reduce the risk of electric shock This product is
equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug
must be plugged into an appropriate outlet that is properly installed and grounded in accordance
with the local codes and regulations

DANGER

Do not modify the plug provided with the product - if it will not fit - have a proper outlet installed
by a qualified electrician

TEMPO / VALUE DISPLAY

The messages contained in the Display may not always match the display pages They are merely
examples of the many features of the product

DISCLAIMER

The information contained in this manual has been very carefully revised. Due to the constant effort
to improve the product, the product specifications might differ to those in the manual. The
specifications are subject to modification without prior notice.

TAKING CARE OF YOUR DIGITAL PIANO

Your Digital Piano is a fine instrument and deserves the most careful treatment.
Follow carefully the next few points, and it will operate at its best for many years.

- Never open the case and touch the internal circuits.

- Always switch the power Off after use.

- Use a cloth or a damp sponge. If the dirt is particularly persistent, use a neutral detergent to

remove it. Never use solvents or alcohol.

- Do not place your instrument near electric motors, neon or fluorescent lamps as these may

generate disturbances.

- In most cases you just need to change the position of the instrument to avoid interference.

- Keep your instrument away from dusty environments, high humidity, and high temperatures.

- Do not use on the same AC outlet with electrical appliances, neon lights or variable lighting

system.

- Before turning on the instrument, make sure that any external amplifier and speaker system

that you have connected to your piano are turned off.

- Computer controlled instruments can be interrupted by spikes, surges and dropouts on the

power line. If your instrument stops working because of a power line disturbance, switch it
off for a few seconds and then switch it on again.

- Never disconnect the power cable without turning the power switch off.

- 3 -

INTRODUCTION

Welcome to the high tech world of electronic instruments. Your piano has been designed and made
using the latest technology and computerised systems, to offer you years of trouble free pleasure.
Read this manual carefully in order to fully exploit the potential of your instrument.

POWER ON

To turn on the instrument simply push the On/Off switch. The default setting will automatically
select the PIANO 1 sound in the VOICE SECTION.

DEMO SONG

The Demo button is located at the right of the control panel. Press this button and the three digits
Led Display will indicate:

This is to indicate d (demo) s (song) number 1. Use the (/\) and (\/) buttons to select one of the
available Demo Songs.
At the end of the selected Demo Song the instrument will automatically play the next Demo Song.
The Demo function can be exit by pressing the DEMO button again even while the Demo is
playing.

CONTROL PANEL

Your instrument's control panel is designed to be easy to use. Most of the controls are single
function. Each control has an LED showing if the function has been activated.
Whenever your instrument is switched on, it will automatically select ACOUSTIC PIANO 1 on the
keyboard.

MASTER VOLUME

The Master Volume slider control adjusts the overall volume of the instrument. If the headphone set
is connected it will also adjust the headphone volume.

- 4 -

VOICE SECTION

To select the sounds listed below the sound buttons make sure that the SELECT button is switched
Off.
Press one of the Voice buttons to select the sound you wish to play. Its Led lights up and you can
play the desired sound.
To select the sounds listed above the sound buttons make sure that the SELECT button is switched
On.
Press one of the Voice buttons to select the sound you wish to play. Its Led lights up and you can
play the desired sound.
It is also possible to play two sounds at the same time, for example PIANO 1 and STRINGS.

- To select the PIANO 1 sound press and hold the related button.

- While holding down the PIANO 1 button also press the STRINGS button.

- The two sounds are now selected and they can be played at the same time.

It is also possible to play two sounds at the same time, selecting them from the top and the bottom
row, for example E.PIANO 1 and BRASS.

- To select the E.PIANO 1 sound press and hold the related button.

- While holding down the E.PIANO 1 button also press the SELECT button to select the

upper row.

- Release now the SELECT button and while holding the E.PIANO1 button press the BRASS

button .

- The two sounds are now selected and they can be played at the same time.

As soon as the second sound is selected the display will indicate

It is now possible to balance the two sounds using the (/\) and (\/) DATA buttons .

- 5 -