Page 1
INSTALLATION INSTRUCTIONS
ALEO
72275T-4ND Single Lever Basin Mixer
98868T-4ND Single Lever Tall Basin Mixer
BEFORE YOU BEGIN
All information is based on the latest product information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. An inline water filter must be used with this product.
3. If possible, install this faucet before installing the lavatory.
4. Inspect the supply tubing for damage and leakage. Replace and maintain as necessary.
5. Observe local plumbing codes.
6. Shut off the water supplies to the fitting.
7. All installations should comply with the relevant requirements of AS/NZS 3500 and AS/NZS 6400.
HANDLE OPERATION
Lift handle gently. Turn clockwise for hot water, turn counter-colckwise for cold water.
ROUGH-IN DIMENSIONS
142
40Max.
450
18º
88
Ø31~Ø37
100
G1/2˝
14º
159
323
268
40Max.
Ø31~Ø37
360
G1/2˝
72275T-4ND 98868T-4ND
1212002-AN2-A 1
Page 2
INSTALLATION
How To Install The Faucet
Install the mounting stud(2) onto the faucet body base(3). Insert lift rod(5) to the
hole at the rear of the body. Slide the washer(4) over the flexible hoses(1) and
mounting stud, and into the groove at the bottom of the faucet body.
Insert the faucet assembly into the lavatory hole. Position the faucet. From
underside of the lavatory, place the brackets(5, Rubber washer is on the top)
onto the mounting stud, and secure the faucet with the nut(6).
Attach the hoses to water supplies. The hose with blue round is for cold water,
the hose with red round is for hot water.
INSTALLATION CHECKOUT
Ensure that all connections are tight. Ensure that the handle is in the off
position. Turn on the drain and main water supply, and check for leaks. Repair
as needed.
SERVICE PARTS
ALEO
72275T-4ND Single Lever Basin Mixer
98868T-4ND Single Lever Tall Basin Mixer
3
2
4
1
5
6
3016002**
833438
3008523
3015547**
1219254
1219253
3008414
871472
Remove the aerator kit(7) by coin. Turn on the faucet. Run hot and cold water
through the faucet for about one minute to remove any debris.
7
Check for leaks. Repair as needed. Remove any debris from the aerator kit.
Shut off the faucet. Reinstall the aerator kit.
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could adversely
affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler faucets and fittings.
1220841 1220841
836664
72275T-4ND:1054592
98868T-4ND:1054593
1212002-AN2-A 2
**Color code must be specified when ordering
1212002-AN2-A 3
Loading...