Page 1
Publication No. 7C8276
16MAR98
INSTALLATION INSTRUCTIONS
for the
DRYER OVERTEMPERATURE THERMOSTAT
on the
Kodak RP X-Omat PROCESSOR, MODEL M6B
Kodak Professional Industrex M6-I PROCESSOR
Kodak X-Omat PROCESSOR, MODEL M6RA
Kodak X-Omat 460 RA PROCESSOR
Kodak X-Omat 480 RA PROCESSOR
HEALTH IMAGING
© Eastman Kodak Company
Page 2
PLEASE NOTE The information contained herein is based on the experience and knowledge relating to the
subject matter gained by Eastman Kodak Company prior to publication.
No patent license is granted by this information.
Eastman Kodak Company reserves the right to change this information without notice, and
makes no warranty, express or implied, with respect to this information. Kodak shall not be
liable for any loss or damage, including consequential or special damages, resulting from any
use of this information, even if loss or damage is caused by Kodak’s negligence or other fault.
This equipment includes parts and assemblies sensitive to damage from electrostatic
discharge. Use caution to prevent damage during all service procedures.
DRYER OVERTEMPERATURE THERMOSTAT includes:
Part No. Description Quantity
8B6902 DRYER OVERTEMPERATURE THERMOSTAT 1
7C8226 STANDOFF 2
7C8276 INSTALLATION INSTRUCTIONS 1
2 16MAR98 – 7C8276
Page 3
Installing the DRYER OVERTEMPERATURE THERMOSTAT
GRILL
back
red RESET BUTTON
2 STANDOFFS
DRYER
OVERTEMPERATURE
THERMOSTAT
H048_0217ECB
H048_0217EA
2 SCREWS
2 WASHERS
7C8276 – 16MAR98 3
Page 4
Warning
Dangerous Voltage
[1] De-energize the PROCESSOR.
[2] Remove:
• AIR TUBES
• ROLLERS
• GRILL
Note
For removal information, see the SERVICE MANUAL for each PROCESSOR.
[3] Disconnect the wires to the DRYER OVERTEMPERATURE THERMOSTAT.
[4] Remove:
• 2 SCREWS and keep
• 2 WASHERS and keep
• DRYER OVERTEMPERATURE THERMOSTAT and discard
[5] Install the 2 new STANDOFFS.
Important
The position of the DRYER OVERTEMPERATURE THERMOSTAT must allow for easy access to the red
RESET BUTTON.
[6] Use the 2 SCREWS and 2 WASHERS from Step 4 to install the new DRYER OVERTEMPERATURE
THERMOSTAT.
[7] Assemble the PROCESSOR.
Note
The red RESET BUTTON is offset on the following PROCESSORS:
PROCESSOR Serial No.
M6RA, 460 RA, 480 RA All
M6B 23,474 and below
M6I 3,135 and below
Publication History
Print Date Pub No. Affected Pages Filename Description
16MAR98 7C8276 All ii3040_2_16mar98.doc First Printing
Kodak, Kodak Professional, Industrex and X-Omat are trademarks.
ii3040_2_16mar98.doc
Printed In USA
EASTMAN KODAK COMPANY
Health Imaging
● ROCHESTER, N.Y. 14650
Loading...