Kodak X-Omatic, Min-R User manual

SERVICE BULLETIN

KODAK X-OMAT Processor

Eastman Kodak Company/Customer & Technical Services/Health Sciences Markets Division/Rochester, New York 14650

SERVICE BULLETIN NO. 199 August 1994

Kodak X-Omatic Identification Camera, Models 4 and 4L

Kodak X-Omatic Identification Camera, Models X-1 and X-1-L

Kodak X-Omatic Identification Camera, Models 2 and 2-L

Kodak Min-R and Min-R L Identification Cameras

A New TOOL Is Available for the Kodak Identification Cameras

An ACTUATOR PIN ALIGNMENT TOOL, Part No. 1C0071, is now available. The tool comes in a
pouch and ‘‘How to Use’’ instructions are included.

The tool is used to adjust the ACTUATOR PIN in the above listed ID cameras after installing a new
ACTUATOR ASSEMBLY or a new STAY ASSEMBLY.

Using this tool with the instructions extends the life of the ACTUATOR and will make it easier to work
on the ID cameras.

For more information, please contact:

Eastman Kodak Company
Imaging Service Center
Health Sciences Division
100 Carlson Road
Rochester, New York 14653-9013
[phone]

Pub. No. N-911
 Eastman Kodak Company, 1994 -1-

svcbul_199.txt
N-911

Kodak, X-Omatic and Min-R are trademarks.

Health Sciences Division

Printed in USA

EASTMAN KODAK COMPANY • ROCHESTER, N.Y. 14650