Kodak CIS-166 User Manual

CIS-166 December 1994

CURRENT INFORMATION SUMMARY

Opening Instructions for the

KODAK MAX Waterproof One-Time-Use Camera

Wear eye protection when opening all cameras.

Remove Wind Knob

• Ensure film is completely wound off.

• Insert tool end as shown and pry WIND KNOB off.

• Remove the black O-RING.

Remove Back Cover (a)

Remove Back Cover (c)

• Carefully pull up each side of the REAR HOUSING cover until it is completely removed.

Remove Back Cover (d)

• Insert special tool into rectangular hole of PULL TAB.

Remove Back Cover (b)

• Pry up on PULL TAB to initiate opening.

CAUTION: T o avoid tool slippage, be sure tool is fully engaged with the camera body before attempting opening task.

• To remove the camera, the REAR HOUSING cover must be completely removed.

Remove Camera from Casing

• Tap the FRONT HOUSING cover on a hard surface to loosen the camera.

• Remove the camera from the housing.

• Remove the film in the same way as typical Fun Saver 35 cameras.

• Place in recycle bin.

• Return to Kodak for recycling.

CIS-166 Opening Instructions for the KODAK MAX Waterproof One-Time-Use Camera

Current Information Summaries provide information of limited or specific

application. Responsibility for judging the timeliness and applicability of the

information to a specific photographic use rests with the end user.

Consumer Imaging

EASTMAN KODAK COMPANY • ROCHESTER, NY 14650

Kodak and Max are trademarks.

Minor Revision 12-98

Printed in U.S.A.