Kodak CFH-V10 User Manual

Quick Start Guide

KODAK Video Monitor CFH-V10

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION TO REDUCE THE RISK OF

QUALIFIED SERVICE PERSONNEL.

This symbol is intended to alert the user
“dangerous voltage” within the product’s

sk of electric

shock to persons.

The exclamation point within an

accompanying the product.

DO NOT REMOVE COVER (OR BACK).

ELECTRIC SHOCK,

NO USER SERVICEABLE PARTS

INSIDE, REFER SERVICING TO

to the presence of uninsulated

enclosure that may be of sufficient

magnitude to constitute a ri

equilateral triangle is intended to alert

the user to the presence of important

operating and maintenance (servicing)

instructions in the literature

Warning

To prevent fire or shock hazards, do not expose this product
to rain or moisture.

Do not expose the product to dripping or splashing and
never place anything containing water or liquid, such as a
vase, on the product.

To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.

2

KODAK Video Monitor CFH-V10

Regulatory Notices for USA

This equipment has been test ed and found to comply
with the limits for a digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interfe ren c e to radi o
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment

and receiver.

- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.

- Consult the dealer or an experienced radio/TV
technician for help.

You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
The shielded interface cable recommended in this
manual must be used with this equipment in order to
comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.

Quick Start Guide 3

KODAK Video Monitor CFH-V10

Camera Mou nt ing

To mount the KODA K Video Monitor
CFH-V10 to a wall, unscrew the base
of the camera and remove th e m etal
plate.

With the included screws and
anchors, fasten the mounting bracket
onto the wall. T hen, reattach the
base cover and screw the stand back
onto the mounting bracket.

4

KODAK Video Monitor CFH-V10

1. iSecurity+ App

To get started, down load the
iSecurity+ app from Apple’s App store
or the Google Pla y Store.

2. Connect to Power

Connect the KODAK Video Monitor
CFH-V10 to the AC power adapter,
then plug the power cord into the
electrical outlet.

Quick Start Guide 5

KODAK Video Monitor CFH-V10

3a. Wi-Fi Setup Mode

Please make sure th e “Wi-Fi Setup”
switch on the back of the camera is
set to ON.

The “Wi-Fi Setup” indicator will glow
green when the KODA K Video Monitor
CFH-V10 is ready for setup. (This
may take up to 2 minutes when t
camera is first powered on.)

6