Keysight Technologies
N9020B/N9021B MXA and
N9030B PXA Signal Analyzer
Option RT1 and RT2 Real Time Spectrum Analysis
Installation Note
Notices
© Copyright 2016 - 2021 Keysight Technologies, Inc.
The information contained in this document is subject to change without notice.
Keysight Technologies makes no warranty of any kind with regard to this material, including but
not limited to, the implied warranties of merchantability and fitness for a particular purpose.
Keysight Technologies shall not be liable for errors contained herein or for incidental or
consequential damages in connection with the furnishing, performance, or use of this material.
Manual Part Number
N9030-90085
Edition
Edition 1, January 2021
Supersedes: February 2016
Printed in USA/Malaysia
Published by:
Keysight Technologies, Inc.
1400 Fountaingrove Parkway
Santa Rosa, CA 95403
Option RT1 and RT2 - Real Time Spectrum Analysis Installation Kit
Option RT1 and RT2 - Real Time Spectrum Analysis Installation Kit
Products Affected: N9020B MXA Signal Analyzer
N9021B MXA Signal Analyzer
N9030B PXA Signal Analyzer
Serial Numbers: All
To Be Performed By: (X) Keysight Service Center
(X) Personnel Qualified by Keysight
(X) Customer
Estimated Installation Time:
Estimated Adjustment and Verification Time:
0.5 Hours
0. Hours
Introduction
This kit contains all of the hardware and instructions required to install either Option RT1 or Option
RT2 on a Keysight N9020B/N9021B MXA and N9030B PXA Signal Analyzer.
1.
The signal analyzer being upgraded must have one of the wide
bandwidth options listed below already installed. To verify that one of
these options is present, press System, Show System, and look under
"Options" for the presence of the options listed.
— For N9020B MXA: Must have N9020B-B85, N9020B-B1A, or N9020B-B1X
— For N9021B MXA: Must have N9021B-B2X or N9021B-B5X
— For N9030B PXA: Must have N9030B-B85 or N9030B-B1X or N9030B-B2X
or N9030B-B5X.
2.
This option is licensed for one instrument model/serial number
combination. The license key will only install on the designated
instrument.
Installation Note N9030-90085 3