Kenwood TK-3160E3 User Manual

INSTRUCTION MANUAL MODE D’EMPLOI MANUAL DE INSTRUCCIONES MANUALE DI ISTRUZIONI BEDIENUNGSANLEITUNG GEBRUIKSAANWIJZING
VHF FM TRANSCEIVER/ UHF FM TRANSCEIVER
ÉMETTEUR-RÉCEPTEUR FM VHF/ ÉMETTEUR-RÉCEPTEUR FM UHF
TRANSCEPTOR DE FM VHF/ TRANSCEPTOR DE FM UHF
RICETRASMETTITORE FM VHF/ RICETRASMETTITORE FM UHF
VHF-FM-TRANSCEIVER/ UHF-FM-TRANSCEIVER
VHF FM ZENDONTVANGER/ UHF FM ZENDONTVANGER
© B62-1788-00 (E, E3) 09 08 07 06 05 04 03 02 01 00
TK-2160/ TK-3160
VHF FM TRANSCEIVER/ UHF FM TRANSCEIVER
INSTRUCTION MANUAL
THANK YOU
We are grateful you chose KENWOOD for your land mobile radio applications. We believe this easy-to-use transceiver will provide dependable communications to keep personnel operating at peak efficiency.
KENWOOD transceivers incorporate the latest in advanced technology. As a result, we feel strongly that you will be pleased with the quality and features of this product.
MODELS COVERED BY THIS MANUAL
TK-2160: VHF FM Transceiver
TK-3160: UHF FM Transceiver
NOTICES TO THE USER
Government law prohibits the operation of unlicensed radio transmitters within the territories under government control.
Illegal operation is punishable by fine or imprisonment or both.
Refer service to qualified technicians only.
Safety: It is important that the operator is aware of and understands hazards common to the operation of any transceiver.
EXPLOSIVE ATMOSPHERES (GASES, DUST, FUMES, etc.)
Turn off your transceiver while taking on fuel, or while parked in gasoline service stations.
i
PRECAUTIONS
Observe the following precautions to prevent fire, personal injury, and transceiver damage.
Do not modify this transceiver for any reason.
Do not expose the transceiver to long periods of direct sunlight, nor place it close to heating appliances.
Do not place the transceiver in excessively dusty, humid, and/or wet areas, nor on unstable surfaces.
If an abnormal odor or smoke is detected coming from the transceiver, switch OFF the power immediately and remove the optional battery pack from the transceiver. Contact your KENWOOD dealer.
ii
CONTENTS
UNPACKING AND CHECKING EQUIPMENT................... 1
SUPPLIED ACCESSORIES ......................................... 1
PREPARATION .................................................. 2
BATTERY PACK PRECAUTIONS .................................... 2
INSTALLING/ REMOVING THE (OPTIONAL) RECHARGEABLE
BATTERY PACK OR ALKALINE BATTERY CASE ...................... 7
INSTALLING/ REMOVING ALKALINE BATTERIES ...................... 8
INSTALLING THE (OPTIONAL) ANTENNA ............................ 9
INSTALLING THE BELT CLIP ....................................... 9
INSTALLING THE COVER OVER THE SPEAKER/ MICROPHONE JACKS .... 10
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE .............10
GETTING ACQUAINTED ....................................... 11
PROGRAMMABLE AUXILIARY FUNCTIONS ..........................14
OPERATING BASICS...........................................15
SWITCHING POWER ON/ OFF .................................. 15
ADJUSTING THE VOLUME .......................................15
SELECTING A CHANNEL .........................................15
MAKING A CALL ...............................................16
RECEIVING A CALL .............................................16
SCAN ...........................................................17
PRIORITY SCAN ................................................17
CHANNEL LOCKOUT ............................................18
REVERT CHANNEL ..............................................18
5-TONE SIGNALLING ..........................................19
RECEIVING ....................................................19
TRANSMITTING .................................................19
iii
(CONTENTS CONTINUED…)
DTMF SIGNALLING ............................................ 20
FleetSync OPERATION ........................................21
CALL TYPES ...................................................21
QUIET TALK (QT)/ DIGITAL QUIET TALK (DQT) ............. 22
SCRAMBLER ...................................................23
VOX OPERATION ..............................................24
EMERGENCY CALLS ..........................................26
ADVANCED OPERATIONS .....................................27
SELECTING AN OUTPUT POWER .................................27
MONITOR/ SQUELCH OFF .......................................27
BACKGROUND OPERATIONS.................................28
TIME-OUT TIMER (TOT) .......................................28
BATTERY SAVE ................................................ 28
LOW BATTERY WARNING .......................................29
BUSY CHANNEL LOCKOUT (BCL) ............................... 29
STUN ......................................................... 29
BEGINNING/ END OF TRANSMISSION (TX) SIGNAL ................29
iv
UNPACKING AND CHECKING EQUIPMENT
Note: The following unpacking instructions are for use by your KENWOOD dealer, an authorized KENWOOD service facility, or the
factory.
Carefully unpack the transceiver. We recommend that you identify the items listed in the following table before discarding the packing material. If any items are missing or have been damaged during shipment, file a claim with the carrier immediately.
SUPPLIED ACCESSORIES
metI rebmuntraP ytitnauQ
pilctleBXX-1070-92J1
gnikcolenohporcim/rekaepS
tekcarb
pacskcajenohporcim/rekaepSXX-6760-90B1
wercsenihcamgnidniBXX-4003-53N1
launamnoitcurtsnIXX-8871-26B1
XX-4648-12J1
Belt clip
Speaker/ microphone
jacks cap
Speaker/ microphone
locking bracket
Binding machine
screw
1
PREPARATION
BATTERY PACK PRECAUTIONS
Do not recharge the battery pack if it is already fully charged. Doing so may cause the life of the battery pack to shorten or the battery pack may be damaged.
After recharging the battery pack, disconnect it from the charger. If the charger power is reset (turned ON after being turned OFF), recharging will start again and the battery pack will become overcharged.
Do not use the transceiver while charging the battery pack. We recommend you switch the transceiver power OFF while charging is taking place.
Do not short the battery terminals or dispose of the battery by fire.
Never attempt to remove the casing from the battery pack.
Information concerning the (optional) Li-ion battery pack:
The battery pack includes flammable objects such as organic solvent. Mishandling may cause the battery to rupture producing flames or extreme heat, deteriorate, or cause other forms of damage to the battery. Please observe the following prohibitive matters.
DANGER
Do not disassemble or reconstruct battery!
The battery pack has a safety function and protection circuit to avoid danger. If they suffer serious damage, the battery may generate heat or smoke, rupture, or burst into flame.
Do not short-circuit the battery!
Do not join the + and – terminals using any form of metal (such as a paper clip or wire). Do not carry or store the battery pack in containers holding metal objects (such as wires, chain-necklace or hairpins). If the battery pack is short-circuited, excessive current will flow and the battery may generate heat or smoke, rupture, or burst into flame. It will also cause metal objects to heat up.
2
Do not incinerate or apply heat to the battery!
If the insulator is melted, the gas release vent or safety function is damaged, or the electrolyte is ignited, the battery may generate heat or smoke, rupture, or burst into flame.
Do not use or leave the battery near fires, stoves, or other heat generators (areas reaching over 80°C/ 176°F)!
If the polymer separator is melted due to high temperature, an internal short-circuit may occur in the individual cells and the battery may generate heat or smoke, rupture, or burst into flame.
Do not immerse the battery in water or get it wet by other means!
If the battery’s protection circuit is damaged, the battery may charge at extreme current (or voltage) and an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.
Do not charge the battery near fires or under direct sunlight!
If the battery’s protection circuit is damaged, the battery may charge at extreme current (or voltage) and an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.
Use only the specified charger and observe charging requirements!
If the battery is charged in unspecified conditions (under high temperature over the regulated value, excessive high voltage or current over regulated value, or with a remodelled charger), it may overcharge or an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.
Do not pierce the battery with any object, strike it with an instrument, or step on it!
This may break or deform the battery, causing a short-circuited. The battery may generate heat or smoke, rupture, or burst into flame.
Do not jar or throw the battery!
An impact may cause the battery to leak, generate heat or smoke, rupture, and/or burst into flame. If the battery’s protection circuit is damaged, the battery may charge at an abnormal current (or voltage), and an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.
3
Do not use the battery pack if it is damaged in any way!
The battery may generate heat or smoke, rupture, or burst into flame.
Do not solder directly onto the battery!
If the insulator is melted or the gas release vent or safety function is damaged, the battery may generate heat or smoke, rupture, or burst into flame.
Do not reverse the battery polarity (and terminals)!
When charging a reversed battery, an abnormal chemical reaction may occur. In some cases, an unexpected large amount of current may flow upon discharging. The battery may generate heat or smoke, rupture, or burst into flame.
Do not reverse-charge or reverse-connect the battery!
The battery pack has positive and negative poles. If the battery pack does not smoothly connect with a charger or operating equipment, do not force it; check the polarity of the battery. If the battery pack is reverse-connected to the charger, it will be reverse-charged and an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame.
Do not touch a ruptured and leaking battery!
If the electrolyte liquid from the battery gets into your eyes, wash your eyes out with fresh water as soon as possible, without rubbing your eyes. Go to the hospital immediately. If left untreated, it may cause eye-problems.
4
Loading...
+ 25 hidden pages