key
permanent filter
filter holder
coffee tank
hot coffee outlet
lid
water reservoir
keep warm plate
coffee dispensing lever
measuring scoop
drip tray
ON/OFF button (CM450 series
only)
CM550 series only
clock
Auto/ON/OFF button
Prog (programme) button
hour button
minute button
to make coffee
1Fill the coffee tank with the desired
amount of water. Use the markings
on the inside below the pouring
spout as a guide. Do not exceed
the “MAX” level.
● Use cold water. We recommend
using filtered water from a
Kenwood Water Filter as it reduces
limescale. Never use warm or fizzy
water.
2Pour the water from the coffee
tank into the water reservoir.
3 Place the coffee tank on the keep
warm plate, then fit the filter
holder.
4 Place the permanent filter into the
filter holder.
5 For each cup of coffee required,
place one level spoon of filter
coffee into the permanent filter.
Adjust quantity to taste.
6 Close the lid.
7 Plug into the power supply.
CM450 series
● Press the “ON/OFF” button, the
light will come on and brewing will
commence.
CM550 series
● Press the “Auto/ON/OFF” button
twice for coffee to be produced
straight away, the light will come
on and brewing will commence. If
you want to use the automatic
brew facility follow the instructions
to set the clock and to programme
automatic brew.
8 To dispense coffee, press the
coffee dispensing lever with a cup
and coffee will flow out. Never
press the dispensing lever
with your hand. To stop the
flow remove the cup. Coffee may
be dispensed during and after
brewing.
● To preserve heat and flavour, DO
NOT open the lid during or just
after brewing.
9 The BrewMaster will keep the
coffee warm and then
automatically switch off after 2
hours. To manually switch off
earlier, press the “ON/OFF” button.
to make tea
Follow the procedure for making
coffee using tea leaves instead of
filter coffee.
Place the desired amount of loose
tea into the permanent filter using
the spoon provided. The amount
will vary depending upon the type
of tea used and individual tastes
but as a guide use 4 - 6 spoons of
loose tea per maximum capacity of
water. Some experimentation will
be necessary to obtain the desired
result.
For best results we recommend
that only the required amount of
tea is made at one time and that
the tea is drunk within half an hour
of brewing.
safety
● Never operate the coffee
dispensing lever by hand, always
use a cup or mug.
● Watch out for steam, never lift the
lid or remove parts during the
brewing cycle.
● Take care when dispensing coffee,
as burns can occur from touching
hot liquids.
● Never touch the keep warm plate
during or after the brewing cycle.
● Always use the handles provided
to remove parts from the
BrewMaster.
● Keep children away from the
machine. And never let the cord
hang down where a child could
grab it.
● Never use a damaged machine.
Get it checked or repaired: see
‘service’.
● Never put the machine in water or
let the cord or plug get wet - you
could get an electric shock.
● Unplug:
●●
before filling with water
●●
before cleaning
●●
after use.
● Never leave the machine on
unattended.
● Don’t let the cord touch hot parts.
● Don’t let infirm people use the
machine without supervision.
● Don’t let children play with this
machine.
● Only use the machine for its
intended domestic use.
● Always make sure there is water in
the water reservoir before
switching on.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
important (UK) only
●
The wires in the cord are coloured
as follows:
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
●
The appliance must be protected
by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable pug is inadvertently
inserted into a 13A socket outlet.
●
This machine complies with
European Economic Community
Directive 89/336/EEC.
before using for the first
time
1Remove all packaging
2 Wash the parts: see ‘care and
cleaning’.
3 Run two lots of water through the
machine (without coffee) to clean it
out. Each time pour one coffee
tank of cold water filled to the
“MAX” level into the water
reservoir. See ‘to make coffee’.
CM450
series
CM550
series