Kenmore Elite 36 Electric Cooktop, Elite 30 Electric Cooktop, 36 Electric Cooktop, 30 Electric Cooktop Installation Guide
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A
QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
fl ammable vapors and liquids in the vicinity of this or any other appliance.
Cooktop Dimensions
30” Min. *
(76.2 cm)
FOR YOUR SAFETY: Do not store or use gasoline or other
IMPORTANT INSTALLATION-INFORMATION
• All electric cooktops run off a single phase, three-wire
or four-wire cable, 240/208 volt, 60 hertz, AC only
electrical supply with ground.
• Please note minimum distances between cooktop and
adjacent and overhead cabinetry is 30" (76.2 cm).
* 30" (76.2 cm) min. for unprotected cabinet
24" (61 cm) min. for protected surface
A
B
C
E
Cooktop Cutout Dimensions
D
H
G
F
Figure 1 - 30" Model shown only
PRODUCT DIMENSIONS
MODEL A. WIDTH B. DEPTH C. HEIGHT D. BOX WIDTH E. BOX DEPTH
30’’ Ceramic Model 305/8 (77.8) 213/8 (54.4) 43/4 (12.1) 281/8 (71.4) 19 (48.3)
36’’ Ceramic Model 365/8 (93) 21½ (54.6) 43/4 (12.1) 331/2 (85.1) 183/4 (47.6)
CUT OUT DIMENSIONS
F. WIDTH G. DEPTH H. HEIGHT BELOW
MODEL MINIMUM MAXIMUM MINIMUM MAXIMUM
30’’ Ceramic Model 28½ (72.4) 30 (76.2) 195/8 (49.8) 201/2 (52.1) 61/2 (16.5)
36’’ Ceramic Model 337/8 (86.1) 36 (91.4) 191/8 (48.6) 201/2 (52.1) 61/2 (16.5)
All dimensions are in inches (cm).
** Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for
installation of the junction box on the wall at the back of the cooktop.
Printed in China
P/N 318205428 (1311) Rev. B
1
COOKTOP*
English – pages 1-6
Español – pages 7-12
Français – pages 13-18
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Overhead Cabinet
Should Not Exceed a
Maximum Depth of
13" (33cm)
L
Min.
30" (76.2cm) Min.
Clearance Between
the Top of the
Cooking Platform
and the Bottom of an
Unprotected Wood
or Metal Cabinet
24" (61cm) Min. when
Bottom of Wood
or Metal Cabinet
is Protected by Not
Less Than 1/8" Flame
Retardant Millboard
Covered With Not Less
Than No. 28 MGS Sheet
Steel, 0.015" (0.4mm)
Stainless Steel, 0.024"
(0.6mm) Aluminum or
0.020" (0.5mm) Copper
18"
(45.7cm)
G
24"
(61cm)
K Min.
Recommended
Distance Between
Rear Edge of
Cutout and Nearest
Combustible
Surface Above
Countertop
F
10"
(25.4cm)
H
12"
(30.5cm)
J Min. From
Edge of
Cooktop
to Nearest
Combustible
Wall (Either
Side of Unit).
Approximate Location
2 1/2" (6.4cm) Min. From
Edge of Cutout to Front Edge
of Countertop
Letters on this fi gure refer to chart on front page except for J, K & L.
CAUTION
or fi re resulting from reaching over heated
surfaces, cabinet storage space located
above the cooktop should be avoided. If
cabinet storage is provided, risk can be
reduced by installing a range hood that
projects horizontally a minimum of 5" (12.7
cm) beyond the bottom of the cabinets.
To eliminate the risk of burns
Figure 2 – COUNTERTOP CUTOUT OPENING
of Junction Box
MODEL J K L
30’’ Ceramic Glass 7 ½’’ (19.1cm) 2’’ (5.1cm) 30" (76.2cm)
36’’ Ceramic Glass 7 ½’’ (19.1cm) 2’’ (5.1cm) 36" (91.4cm)
2
For a drawer installation
below the cooktop, allow
8"(20.4cm) of clearance
underneath the countertop.
The drawer must not interfere
with the electrical installation
of the cooktop or contain
fl ammable materials.
Loading...