Page 1
The$BR-EN900$Quick$Setup$Guide
192.168.1.3
• Set$PC$IP$address$to$192.168.1.xxx
• Connect$to$the$Ethernet$1$port
• Enter$192.168.1.3 in$the$browser
• Default$password$– jvc1234(
• Configure$IP(address,$Default(Gateway(and$DNS servers
• Confirm$that$Use(as(Primary(Default(Gateway(is$“checked”$for$the$LAN$port$in$use.$
• Click$Apply to$save$settings
SDI
HDMI
DVI-D
H.264
• UDP$TS
• RTP$TS
• Pro-MPEG$(RTP+SMPTE2022$FEC)
• Zixi
• RTP$ES$(RTSP$pull)
• UDP$TS
• RTP$TS
• Pro-MPEG$(RTP+SMPTE2022$FEC)
• Zixi
• RTMP$(CDN)
HEVC
The BR-EN900 features two encoding channels – HEVC and H.264, each with a separate IP destination.
Input must be selected in the HEVC channel settings, the H.264 channel will follow HEVC selection.
Remember to click Apply after any change.
Save existing configuration and select Auto Start
to apply all settings after power OFF/ON
Save$Configuration
Select$Auto(Start
Select$Input
Configure$channels
Both channels encode video from the same input but can
stream to different destinations / IP addresses.
Protocols:
Page 2
The$BR-EN900$encoding$(HEVC$and$H.264)$Start/Stop$is$controlled$in$the$Actions section$of$the$GUI.$
In order to make any changes to encoding parameters, each channel must be stopped and restarted
after changes are applied. To automatically start encoding upon power ON, save Configuration and
enable the Auto Start. Configuration captures the current status of the encoder with all associated
settings, so channels must be running prior to saving the Configuration.
Saved$Configuration Auto(Start(enabled
Zixi$Server$Input-ID Zixi$Server$Input-ID-Password
Preset$Latency$(ms)
Error$Correction$
Overhead
100-1,499
FEC$+$ARQ up$to$30%
1,500$- 8,000 ARQ$only
5%
Streaming-to-Zixi-Server.
Latency value affects the efficiency of error
correction and should be selected based on the
quality of the Internet connection.
Zixi streaming protocol features the most resilient video transport over the
Internet and is highly recommended for sending live video over WANs.
Channel Name and Password should match the Zixi server settings.
UDP Packet Size consideration:
Each data transfer protocol encapsulation increases the packet size.
When packet size exceeds the MTU, it will be fragmented.
Some ISPs reject fragmented packets due to security concerns.
Rejected packets = lost packets, video may become corrupted.
When using Zixi or Pro-MPEG protocols, streaming via Bonded LTE
(or other VPN) it is recommended to reduce the UDP Packet Size to 1128.
Start$/$Stop$encoding
Full$version$of$User(Manual(is$located$in$the$Help section$or$at$pro.jvc.com$
Zixi$Server$IP-Address
FEC – Forward Error Correction
ARQ – Automatic Repeat Request
Loading...