JOY-IT RPI4 CASE MM IR Instructions

MULTIMEDIA CASE

for the Raspberry Pi 4

www.joy-it.net

Pascalstr. 8 47506 Neukirchen-Vluyn

1. ASSEMBLING

1. The first step in assembling the housing is to disassemble the

case into its individual parts. You can easily pull it apart as the case

is attached with magnets.

2. Then connect the AUX plug to the jack socket from the Raspberry Pi.
Now insert the already written SD card into the Raspberry Pi. You
find more information about that in Chapter 2: Soware

installation. Also attach the heat sink to the CPU of the Raspberry

Pi.

3. Aerwards, connect the small board to the two microHDMI connec­tors.

Optionally, you can now connect the cable from the AUX connector
to the appropriate socket on the circuit board. The cable should lie

as flat as possible against the board, otherwise space problems

may occur.

www.joy-it.net

Pascalstr. 8 47506 Neukirchen-Vluyn

4. Now place the Raspberry Pi with the circuit board on the bottom of

the case.

5. In the following step, attach the center piece and push the

connection panel into the center piece.

6. Therefore, place the large board on the GPIO bar of the Raspberry

Pi. The circuit board is inserted at a slight angle so that the
connections fit easily into the panel.

Important:

Should you use the audio cable, care must be taken to ensure that
the cable does not get under the jumper pins on the bottom, other
wise the top PCB will not mount correctly.

7. Connect now the fan, which is attached at the cover, to the big

board. Make sure that the red cable is connected to "+ " and the
black cable to "-".