Jetway Computer NMF93-Q77 User Manual

USER'S MANUAL

Intel Q77 Express Chipset

Based

M/B for LGA 1155 Quad Core Ready

Intel Core Processor

No. G03-NMF93-F

Rev: 1.0

Release date: June 5, 2012

Trademark:

* Specifications and Information contained in this docume ntation ar e furnishe d for inf ormation use only , and ar e

subject to change at any time without notice, and should not be construed as a commitment by manufacturer.

ENVIRONMENTAL SAFETY INSTRUCTION...........................................................................iii

ENVIRONMENTAL PROTECTION ANNOUCEMENT..............................................................iii

USER’S NOTICE .......................................................................................................................iv

MANUAL REVISION INFORMATION.......................................................................................iv

ITEM CHECKLIST.....................................................................................................................iv

CHAPTER 1 INTRODUCTION OF THE MOTHERBOARD

1-1 SPECIFICATION.........................................................................................................1

1-2 LAYOUT DIAGRAM....................................................................................................2

CHAPTER 2 HARDWARE INSTALLATION

2-1 JUMPER SETTING.....................................................................................................5

2-2 CONNECTORS AND HEADERS................................................................................7

2-2-1 REAR I/O BACK PANEL CONNECTORS....................................................7

2-2-2 MOTHERBOARD INTERNAL CONNECTORS............................................8

2-2-3 HEADER PIN DEFINITION ...........................................................................10

TABLE OF CONTENT

CHAPTER 3 INTRODUCING BIOS

3-1 ENTERNING SETUP...................................................................................................16

3-2 BIOS MENU SCREEN ................................................................................................16

3-3 FUNCTION KEYS .......................................................................................................17

3-4 GETTING HELP ..........................................................................................................17

3-5 MENU BARS...............................................................................................................18

3-6 MAIN MENU................................................................................................................18

3-7 ADVANCED MENU.....................................................................................................19

3-8 CHIPSET MENU..........................................................................................................25

3-9 BOOT MENU...............................................................................................................28

3-10 SECURITY MENU.......................................................................................................29

3-11 SAVE & EXIT MENU...................................................................................................30

Environmental Safety Instruction

z Avoid the dusty, humidity and temperature extremes. Do not place the product in

any area where it may become wet.

z 0 to 40 centigrade is the suitable temperature. (The figure comes from the request

of the main chipset)

z Generally speaking, dramatic changes in temperature may lead to contact

malfunction and crackles due to constant thermal expansion and contraction from the welding spots’ that connect components and PCB. Computer should go through an adaptive phase before it boots when it is moved from a cold environment to a warmer one to avoid condensation phenomenon. These water drops attached on PCB or the surface of the components can bring about phenomena as minor as computer instability resulted from corrosion and oxidation from components and PCB or as major as short circuit that can burn the components. Suggest starting the computer until the temperature goes up.

z The increasing temperature of the capacitor may decrease the life of computer.

Using the close case may decrease the life of other device because the higher temperature in the inner of the case.

z Attention to the heat sink when you over-clocking. The higher temperature may

decrease the life of the device and burned the capacitor.

Environmental Protection Announcement

Do not dispose this electronic device into the trash while discarding. To minimize pollution and ensure environment protection of mother earth, please recycle.

iii

USER’S NOTICE

COPYRIGHT OF THIS MANUAL BELONGS TO THE MANUFACTURER. NO PART OF THIS MANUAL, INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT MAY BE REPRODUCED, TRANSMITTED OR TRANSLATED INTO ANY LANGUAGE IN ANY FORM OR BY ANY MEANS WITHOUT WRITTEN PERMISSION OF THE MANUFACTURER.

THIS MANUAL CONTAINS ALL INFORMATION REQUIRED TO USE THIS MOTHER-BOARD SERIES AN D WE DO ASSURE THIS MANUAL MEETS USER’S REQUIREMENT BUT WILL CHANGE, CORRECT ANY TIME WITHOUT NOTICE. MANUFACTURER PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY KIND, AND WILL NOT BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF USE OF DATA, INTERRUPTION OF BUSINESS AND THE LIKE).

PRODUCTS AND CORPORATE NAMES APPEARING IN THIS MANUAL MAY OR MAY NOT BE REGISTERED TRADEMARKS OR COPYRIGHTS OF THEIR RESPECTIVE COMPANIES, AND THEY ARE USED ONLY FOR IDENTIFICATION OR EXPLANATION AND TO THE OWNER’S BENEFIT, WITHOUT INTENT TO INFRINGE.

Manual Revision Information

Reversion Revision History Date

1.0 First Edition June 5, 2012

Item Checklist

Motherboard

User’s Manual

DVD for motherboard utilities

Cable(s)

I/O Back panel shield

Chapter 1

Introduction of the Motherboard

1-1 Specification

Spec Description Design Chipset

LGA1155 CPU Socket

Memory Slot

Expansion Slots

Storage Dual LAN Chip

HD Audio Chip BIOS

Multi I/O

z u-ATX form factor; PCB size: 24.4 x24.4 cm z Intel Q77 Express Chipset z Supports 3rd and 2nd Generation Intel® Core™ i7, Core™ i5,

Core™ i3 series processor in LAG1155 Package

* for detailed CPU support information please visit our website

z DDRIII RAM module slot x 4 z Supporting four DDRIII 1600/1333/1066MHz RAM Module

expandable to 32 GB (Maximum)

z Support dual-channel function z 1 pcs* PCI-Express x16 slot z 1 pcs* PCI-Express x4 slot z 1 pcs* PCI-Express x1 slot z 1 pcs *32-bit PCI slot z 1 pcs* Full-size Mini-PCIE slot/MSATA slot z Support two SATAIII ports and four SATAII ports with RAID

0/1/5/10 function

z Integrated Intel 82574L and 82579LM Gigabit Ethernet LAN chip

that supports Fast Ethernet LAN function of providing 10/100/1000Mbps Ethernet data transfer rate

z Realtek ALC662 6-channel Audio Codec integrated z Audio driver and utility included z 64MB DIP Flash ROM

z USB 3.0 port connector x2 z HDMI port connector x1 z Serial port connector x2 z DVI-D port connector x1 z VGA port connector x1 z USB 2.0 port connector x4 z RJ-45 port LAN connector x2 z Audio connector x3 (Line-in, Line-out, MIC) z Front panel audio header x1 z HDMI-SPDIF header x1 z PS/2 keyboard & mouse header x1 z Parallel header x1 z TPM 1.2 header x1 z GPIO header x1 z USB 2.0 header x2 (Support 4* additional USB 2.0 ports) z USB 3.0 header x1 (Support 2* additional USB 3.0 ports) z Front panel header x1 z POWER LED header x1 z Speaker header x1 z CIR header x1 z LANLED header x2 z SM_BUS header x1 z TX-RX COM header x 1 z COM port header x 8

1-2 Layout Diagram

Rear IO Diagram

USB 3.0 Ports

HDMI Port

Serial Port 1

Serial Port 2

Motherboard Internal Diagram

KBMS Header

USB 3.0 Ports

Over HDMI port

Serial Ports

(COM1 over COM2)

SYS FAN1 Header

Power Connector

DVI-D Port

VGA Port

ATX 12V

CPUFAN Header

RJ-45 LAN Ports

Line-IN/

Optical SPDIF OUT

Line-OUT

MIC-IN

USB 2.0 Ports

DDRIII

DIMM Slot x 4

DVI –D Port

over VGA Port

RJ-45 LAN Port

Over USB 2.0 Ports

RJ-45 LAN Port

Over USB 2.0 Ports Audio Connectors

LAN1LED Header

TX-RX COM Header

PCI Ex

ress 2.0 x1 Slot

LAN2LED Header

Front Panel

Audio Heade

HDMI S/PDIF Header

Note:

1.PE1

slot supports

PCI-Express 3.0 x1

MINI PCI-E

and share with SATA6;

LGA1155

CPU Socket

USB 3.0 Header

PCI Express x 16 Slot (PE1) *

PCI Express 2.0 x 4 Slot

32-bit PCI Slot

Parallel Header

Serial Ports (COM3/4/5/6)

PCI-Express 2.0 x16

6 specification when using Intel

Full-size Mini-PCIE

CIR Header

GPIO Header

TPM Header

specification when using Intel

Ivy Bridge CPU;

/MSATA Slot*

WR LED Header

USB 2.0 Headers

ATX Powe

Connector

SYS FAN2 Header

SM_BUS Header

SATAIII Ports

Intel Q77

Chipset

(SATA1/2)

SATAII Ports

(SATA3/4/5/6)

Speaker Header

Front Panel Header

Serial Ports

(COM7/8/9/10)

Sandy Bridge CPU and supports

mSATA slot

is selectable with

full size

JBAT

Motherboard Jumper Position

CASE_OPEN

JP4

Jumper

Jumper Name Description

JBAT CMOS RAM Clear Function Setting 3-pin Block JP1 COM1 Ports Pin9 Function Select 6-pin Block JP2 Mini PCI-E Power VCC3.3V/3.3VSB Select 3-pin Block JP4 COM3 Header Pin9 Function Select 6-pin Block JP12 COM3 Header RS232/485/422 Function Select 6-pin Block JP8 COM4 Header Pin9 Function Select 6-pin Block Case_open Case Open Message Display Function Select 2-pin Block

Connectors

Connector Name

ATXPWR ATX Power Connector ATX12V1 ATX 12V Power Connector USB4 USB 3.0 Connector X2 HDMI High-Definition Multimedia Interface VGA Video Graphic Attach Connector DVI DVI-D Port Connector COM1(Top)/COM2(Bottom) Serial Port COM Connector X2 UL1(Middle & Bottom)/UL2(Middle & Bottom) USB 2.0 Port Connector X4 UL1(Top)/UL2(Top) RJ-45 LAN Connector X2 AUDIO1 Audio Connector X3 SATA1/SATA2 SATAIII Connector X2 SATA3/SATA4/SATA5/SATA6 SATAII Connectors X4

Headers

Header Name Description

FP_AUDIO Front panel audio Header 9-pin block HDMI_SPDIF HDMI_SPDIF Out Header 2-pin Block KBMS PS/2 Keyboard & Mouse Header 6-pin Block SPEAK Speaker Header 4-pin Block PWRLED Power LED 3-pin Block JW_FP

(Front Panel Header) CIR CIR Header 7-pin Block

USB1 USB 3.0 Header 19-pin Block USB2/USB3 USB 2.0 Header 9-pin Block COM 3/4/5/6/7/8/9/10 Serial Port Header 9-pin Block TX-RXCOM RS 422/485 port header 4-pin block GPIO_CON GPIO Header 10-pin Block TPM TPM Header 19-pin Block PARALLEL Parallel Port Header 25-pin Block LAN1LED/LAN2LED LANLED Header 2-pin Block SM_BUS SMBUS Header 4-pin Block SYSFAN1 SYSFAN1 Header 3-pin Block SYSFAN2/CPUFAN FAN Header 4-pin Block

PWR LED/ HDD LED/ /Power Button

/Reset

9-pin Block

;

Chapter 2

Hardware Installation

2-1 Jumper Setting

(1) JBAT (3-pin): Clear CMOS

JBAT

1-2 closed : Normal

CMOS Clear Setting

(2) JP1 (6-pin): COM1 Ports Pin9 Function Select

JP1

1-2 closed: RS232;

JBAT

2-3 Short： Clear CMOS

3-4 closed : +12V;

5-6 closed : +5V

(3)JP2 (3-pin): Mini PCI-E Power VCC 3.3V/3.3 VSB Select

JP2

1-2 closed: MINI PCI-E VCC= 3.3V;

JP2

2-3 closed: MINI PCI-E VCC= 3.3VSB

(4) JP4 (6-pin): COM3 Port Pin9 Function Select

JP4

1-2 closed: RS232;

3-4 closed : +12V;

(5) JP12 (6-pin): COM3 Header RS232/485/422 Function Select

JP12

1-2 closed: RS232;

3-4 closed : RS485;

(6) JP8 (6-pin): COM4 Port Pin9 Function Select

5-6 closed : +5V

5-6 closed : RS422

JP8

1-2 close d: RS232;

3-4 closed : +12V;

5-6 closed : + 5V

(7) CASE_ OPEN (2-pin): Case Open Message Display Function Select

Pin 1-2 shorted: Case open display function enabled. Use needs to enter BIOS and enable ‘Case Open Detect’ function. In this case if you case is removed, next time when you restart your computer a message will be displayed onscreen to inform you of this.

2-2 Connectors and Headers 2-2-1 Rear I/O Back Panel Connectors

USB 3.0 Ports

Serial Port 1

DVI-D Port

RJ-45 LAN Ports

Optical SPDIF OUT

Line-OUT

MIC-IN

VGA Port

HDMI Port

Serial Port 2

(1) USB 3.0 Port Connector: USB4

These USB 3.0 connectors are for user to connect USB 3.0 compatible devices to the system board.

(2) D-Sub 15-pin Connector: VGA

VGA connector is the 15-pin D-subminiature female connector; it is for the display devices, such as the CRT monitor, LCD monitor and so on.

(3) Digital Visual Interface: DVI

This interface standard designed to maximize the visual quality of digital display devices such as flat panel LCD computer displays and digital projectors.

(4) High-Definition Multimedia Interface: HDMI

This point-to-point interface is for audio and video signals designed as a single-cable solution for home theater and consumer electronics equipment.

USB 2.0 Ports

Line-IN/

NOTE! DVI and HDMI Connector can not be used at the same time.

+ 23 hidden pages