* Specifications and Information contained in this documentation are furnished for i nforma tion use only , a nd are
subject to change at any time without notice, and should not be construed as a commitment by manufacturer.
Environmental Protection Announcement
Do not dispose this electronic device into the trash while discarding. To minimize
pollution and ensure environment protection of mother earth, please recycle.
3-11 SAVE & EXIT MENU...................................................................................................38
ii
Environmental Safety Instruction
z Avoid the dusty, humidity and temperature extremes. Do not place the product in
any area where it may become wet.
z 0 to 60 centigrade is the suitable temperature. (The figure comes from the request
of the main chipset)
z Generally speaking, dramatic changes in temperature may lead to contact
malfunction and crackles due to constant thermal expansion and contraction from
the welding spots’ that connect components and PCB. Computer should go
through an adaptive phase before it boots when it is moved from a cold
environment to a warmer one to avoid condensation phenomenon. These water
drops attached on PCB or the surface of the components can bring about
phenomena as minor as computer instability resulted from corrosion and oxidation
from components and PCB or as major as short circuit that can burn the
components. Suggest starting the computer until the temperature goes up.
z The increasing temperature of the capacitor may decrease the life of computer.
Using the close case may decrease the life of other device because the higher
temperature in the inner of the case.
z Attention to the heat sink when you over-clocking. The higher temperature may
decrease the life of the device and burned the capacitor.
iii
USER’S NOTICE
COPYRIGHT OF THIS MANUAL BELONGS TO THE MANUFACTURER. NO PART OF THIS MANUAL,
INCLUDING THE PRODUCTS AND SOFTWARE DESCRIBED IN IT MAY BE REPRODUCED, TRANSMITTED
OR TRANSLATED INTO ANY LANGUAGE IN ANY FORM OR BY ANY MEANS WITHOUT WRITTEN
PERMISSION OF THE MANUFACTURER.
THIS MANUAL CONTAINS ALL INFORMATION REQUIRED TO USE THIS MOTHER-BOARD SERIES AN D WE
DO ASSURE THIS MANUAL MEETS USER’S REQUIREMENT BUT WILL CHANGE, CORRECT ANY TIME
WITHOUT NOTICE. MANUFACTURER PROVIDES THIS MANUAL “AS IS” WITHOUT WARRANTY OF ANY
KIND, AND WILL NOT BE LIABLE FOR ANY INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL
DAMAGES (INCLUDING DAMAGES FOR LOSS OF PROFIT, LOSS OF BUSINESS, LOSS OF USE OF DATA,
INTERRUPTION OF BUSINESS AND THE LIKE).
PRODUCTS AND CORPORATE NAMES APPEARING IN THIS MANUAL MAY OR MAY NOT BE
REGISTERED TRADEMARKS OR COPYRIGHTS OF THEIR RESPECTIVE COMPANIES, AND THEY ARE
USED ONLY FOR IDENTIFICATION OR EXPLANATION AND TO THE OWNER’S BENEFIT, WITHOUT
INTENT TO INFRINGE.
Manual Revision Information
Reversion Revision History Date
2.0 Second Edition May 14th, 2013
Item Checklist
5
Motherboard
5
DVD for motherboard utilities
5
User’s Manual
5
Cable(s)
5
I/O Back panel shield
iv
Chapter 1
Introduction of the Motherboard
1-1 Feature of Motherboard
Intel® H61 express chipset
z
Support LGA 1155 CPU socket Intel® Core™ i7 processors / Intel® Core™ i5
z
processors / Intel® Core™ i3 processors
Support DDRIII 1066-1333 SO-DIMM up to 16GB and dual channel function
z
Integrated with Realtek RTL8111EVL Gigabit Ethernet LAN chip
z
Integrated with RealTek ALC662-GR 6-channel HD Audio Codec
z
Support USB 2.0 data transport demands.
z
Support PCIE 2.0 x16 by 16 Lane slot and Mini PCI-E slot
Processor, Intel® Core™ i3 Processor in the LGA 1155
Socket
* for detailed CPU support information please visit our website
DDRIII SO-DIMM slot x 2
Support DDRIII 1066/1333 MHz SO-DIMM expandable to
16GB
Support dual channel function
PCIE 2.0 x16 by 16 lane slot x1
Mini-PCIE slot x1
Integrated with Realtek RTL8111EVL PCI-E Gigabit LAN
chips
Support Fast Ethernet LAN function of providing
10/100/1000 Mbps Ethernet data transfer rate
Realtek ALC662-GR 6-channel Audio Codec integrated
Audio driver and utility included
32M DIP Flash ROM
COM port connector x 4
DVI-D port connector x1
VGA port connector x1
RJ-45 LAN connector x1
USB 2.0 port connector x 3
Audio connector x1 (Line-in, Line-out, MIC)
SATAII Connector x4
Front panel audio header x1
2
Parallel port header x1
z
PS/2 keyboard & mouse header x1
z
GPIO header x1
z
TPM 1.2 header x1
z
Serial port header x2
z
RS422/RS485 header x1
z
9-pin USB 2.0 header x2
z
CIR header x1
z
Speaker header x1
z
PWRLED header x1
z
Front panel header x1
z
HDMI_SPDIF header x1
z
1-3 Layout Diagram
Rear IO Diagram
Serial Ports
DVI-D Port
RJ-45 LAN Port
USB Port
Line-IN
Line-OUT
MIC-IN
Serial Ports
VGA Port
USB Ports
3
Motherboard Internal Diagram
r
r
r
r
r
r
r
t
r
r
t
t
Serial Ports
Serial Ports
PS/2 KB &MS
Header
DVI-D Port
over VGA Port
RJ-45 Port over
USB Ports
USB Por
GPIO Heade
TPM Heade
Serial Port Headers
CIR Header
Mini-PCIE Slot
ATX 12V Power Connector
Parallel Port
Header
SATAII Ports
TX-RX COM6
Header
SYSFAN1 Heade
Intel H61 Chipset
CPUFAN Heade
ATX PowerConnector
PWRLED
Heade
USB Headers
SODIMM1
Slo
Speaker Heade
Front Panel
Heade
SYSFAN2Heade
SODIMM2
Slo
Intel LGA1155
CPU Socket
Audio Connector
HDMI_SPDIF
Header
Front Panel
Audio Heade
PCI Express 2.0 x16 by 16 Lane slot
4
Motherboard Jumper Position
JP3
JP4
JP5
JBAT
CASE OPEN
5
Jumper
Jumper Name Description
JBAT CMOS RAM Clear Function Setting 3-pin Block
JP3 COM6 Header RS232/485/422 Function Select6-pin Block
JP4 COM1 Header RS232 Power Select 6-pin Block
JP5 MINIPCI-E VCC 3.3V/SB 3.3VSelect 3-pin Block
CASE OPEN Case Open Message Display Function 2-pin Block
Connectors
Connector Name Description
ATXPWR ATX Power Connector 24-pin Block
ATX12V ATX 12V Power Connector 4-pin Connector
COM3,COM4 &
COM1, COM2
DVI-D DVI-D Port Connector 24-pin Connector
VGA1 Video Graphic Attach Connector 15-pin Female
RJ-45 (from LAN 1) RJ-45 LAN Connector 8-pin Connector
USB (from UL1,USB3) USB 2.0 Port Connector 4-pin Connector
AUDIO1 Line In/ Line Out /MIC Audio
SATA1/SATA2/
SATA3/SATA4/
Serial Port Connector 9-pin Connector
3 -phone Jack
Connector
SATAII Connector 7-pin Connectors
6
7
Headers
Header Name Description
FP_AUDIO Front Panel Audio Header 9-pin block
COM5/COM6 Serial Port Header 9-pin Block
TX-RXCOM6 RS 232/422/485 port header 4-pin block
GPIO_CON GPIO Header 10-pin Block
USB1/USB2 USB Header 9- pin Block
JW_FP
PWR LED Power LED 3-pin Block
SPEAK Speaker Header 4-pin Block
SYSFAN1 FAN Speed Header 3-pin Block
CPU FAN/SYSFAN2 FAN Speed Header 4-pin Block
CIR CIR Header 7-pin Block
KBMS PS2 Keyboard & Mouse Header 6-pin Block
HDMI_SPDIF SPDIF Out header 2-pin block
LANLED LAN LED header 2-pin block
TPM TPM 1.2 Header 19-pin Block
PARALLEL Parallel Port Header 25-pin Block
Front Panel Header(PWR LED/
HD LED/ /Power Button /Reset)
9-pin Block
Chapter 2
Hardware Installation
2-1 Jumper Setting
(1) JBAT (3-pin): Clear CMOS Function Setting
1
3
1-2 closed: Normal;
JBATJBAT
1
3
2-3 closed : Clear CMOS
(2) JP3 (6-pin): COM6 Header RS232/485/422 Function Select
JP3
1
1-2 Closed: RS232;
8
3-4 Closed : RS485;
1 1
5-6 Cl o se d : RS 42 2
(3) JP4 (6-pin): COM1 RS232 Power Select
JP4
1
1-2 Closed: RS232;
1
3-4 Closed : +12V;
1
5-6 Closed : +5V
(4) JP5 (3-pin): Mini PCI-E VCC3.3V/ SB 3.3 V Select
JP5
1-2 Closed : MINI PCI -E VCC= 3.3 V Se l ec t;
JP5
2-3 Closed : MINI PCI-E VCC= 3.3VSB Select
3
3
1
(5)CASE OPEN (2-pin): Case Open Message Display Function Select
Pin 1-2 shorted: Case open display function enabled. In this case if you case is
removed, next time when you restart your computer a message will be displayed
onscreen to inform you of this.
9
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.