Jensen CD-565 User Manual

Portable Stereo Bluetooth

Music System with CD

USER MANUAL
CD-565

PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING

THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.

WARNING

TO PREVENT FIRE OF SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE
FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

The Caution Marking is located at the bottom enclosure of the apparatus.
The Rating plate is located at the bottom enclosure of the apparatus

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that product heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade or the third prong is provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table recommended by the
manufacturer, or sold with the product. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms or when unused for a long
period of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to
rain or moisture, does not operate normally, or has been dropped.

E1

15. This appliance shall not be exposed to dripping or splashing water and that no object filled
with liquids such as vases shall be placed on the apparatus.

16. Do not overload wall outlet. Use only power source as indicated.

17. Use replacement part as specified by the manufacturer.

18. Upon completion of any service or repairs to this product, ask the service technician to
perform safety checks.

19. Power Sources - This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power supply to your
home, consult your product dealer or local power company. For products intended to
operate from battery power, or other sources, refer to the operating instruction.

20. Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short-out parts that could result
in a fire or electric shock. Never spill liquid of any kind on the product.

21. Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
a) When the power-supply cord or plug is damaged,
b) If liquid has been spilled, or objects have fallen into the product,
c) If the product has been exposed to rain or water,
d) If the product does not operate normally by following the operating instructions. Adjust

only those controls that are covered by the operating instructions as an improper
adjustment of other controls may result in damage and will often require extensive

work by a qualified technician to restore the product to its normal operation.
e) If the product has been dropped or damaged in any way, and
f) When the product exhibits a distinct change in performance - this indicates a need for

service.

22. Mains plug is used as disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus from the mains completely, the mains
plug should be disconnected from the mains socket outlet completely.

23. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

24. Excessive sound pressure from earphones and headphone can cause hearing loss.

25. Minimum distances of 4 inches around the apparatus for sufficient ventilation.

26. The ventilation should not be impeded by covering the ventilation openings with items,
such as newspapers, table-cloths, curtains, etc.

27. No naked flame sources, such as lighted candles, should be placed on the apparatus.

28. The use of apparatus in moderate climates.

29. Attention should be drawn to the environmental aspects of battery disposal.

This symbol indicates that this product incorporates double insulation
between hazardous mains voltage and user accessible parts.

SAVE THESE INSTRUCTIONS

E2

COMPLIANCE WITH FCC REGULATIONS

FCC ID: 2ASQA6961448

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may

cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B Digital
Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.

- Consult the dealer or an experienced radio/TV technician for help.

WARNING
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.

CAUTION

Follow the advice below for safe operations.

ON PROTECTION AGAINST LASER ENERGY EXPOSURE

As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to

disassemble the casing.
Stop operation immediately if any liquid or solid object should fall into the cabinet.
Do not touch the lens or poke at it. If you do, you may damage the lens and the player may

not operate properly.

E3

Do not put anything in the safety slot. If you do, the laser diode will be ON when the CD

door is still open.

If the unit is not to be used for a long period of time, make sure that all power sources are

disconnected from the unit. Remove all batteries from the battery compartment.

This unit employs a laser. The use of controls or adjustment or performance of procedures

other than those specified here may result in exposure to hazardous radiation.

ON CONDENSATION

When left in a heated room where it is warm and damp, water droplets or condensation may

form inside the unit.

When there is condensation inside the unit, the unit may not function normally. Let it stand

for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before

use.

Should any trouble occur, disconnect the AC Adapter and refer servicing to qualified
personnel.

PROTECT YOUR FURNITURE

This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving
when

you

operate the controls. These ‘feet’ are made from non-migrating rubber material
specially
types of oil based
rubber ‘feet’ to soften, and
To prevent any damage to your furniture we strongly recommend that you purchase small
self­everywhere
product on fine

formulated

adhesive felt pads, available at hardware stores and home improvement centers

and

to avoid leaving any marks or stains on your furniture. However certain

furniture

apply these pads to the bottom of the rubber ‘feet’ before you place the

wooden furniture.

polishes, wood preservatives, or cleaning sprays may cause the

leave

marks or a rubber residue on the

furniture.

E4