Jensen BUDDY User Manual
1x
1x
1x
1
100%
2 hours
Charging your speaker
Please charge your speaker for 2 hours.
The front LED light will lit red when charging and then turn off when fully charged.
You can use the speaker while charging.
2
Power on your speaker
Press and hold the power button for 3 seconds.
Your speaker is now ready to be connected (LED flashing blue on front)
3 seconds
Flashing
blue
3
Connect your device
From your bluetooth device
open the bluetooth menu
and connect to Buddy.
ON
Bluetooth
General
Bluetooth
Devices
Buddy Not Connected
Telenor
12:15 97%
Charging cable
Audio cable
Charger
Select
Buddy
ON
Bluetooth
Min enhet
Tilgjengelige enheter
Min telefon
Bare synlig for parede enheter
Buddy
Søk
12:15
Select
Buddy
Disconnect
You can disconnect a connected bluetooth device by pressing the power button for 1 second.
The speaker is now ready to be connected by a new bluetooth device. (LED flash blue)
Press for 1 second
Flashing
blue
LED light
i
= Not connected / pairing mode
= Low battery
= Charging
Hereby, Jensen Scandinavia AS, declares that Buddy is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. The declaration of confirmity may be consulted at www.jensenscandinavia.com/rtte/
• A fully charged battery gives up to 12 hours playback time when used
at 50% sound level.
• The speaker will switch off automatically if not used for 10 minutes.
• The speaker are dust protected and can resist water immersion up
to 1m for 5 minutes.
• The speaker can be used in rainy conditions.
• If the speaker has been immersed in water, please drain by shaking the
speaker with connectors facing down.
Warranty
Your speaker has 3 years warranty from the date of purchase.
Water proof warranty (immersed in water) is limited to 1 year.
Important information
i
i
Solid BLUE
Flashing BLUE
Flashing WHITE
Solid RED
= Connected
Loading...