Jensen AWM950 User Manual

AWM950
High Power AM/FM/DVD Player
Owner’s Manual
Designed Specifically for the
Thank you for your purchase of the AWM950. It is designed to give you good value and many hours of
listening enjoyment. Please read this manual carefully, as it should be able to answer many of your questions about the operation and features of this product.
IMPORTANT NOTES
Avoid installing unit in locations described below:
-Places exposed to heat radiating appliances such as electric heaters
-On top of other equipment that radiates heat
-Places lacking ventilation or dusty places
-Humid or moist places
Features:
-AM/FM Wallmount Stereo with DVD Player
-Suspended Automotive DVD Deck Mechanism
-Electronic Tuner
-Locking Power / Speaker Connector
-Clock /Alarm
-2-Channel (Left, Right with A/B Speaker Outputs)
-Auxiliary Input Function
-Backlit Controls
-Reverse P olarity Protection
-50 Watts Power Output
-12VDC
-US/European Bands
-Bass/Treble
-Alarm Defeat Switch
REAR PANEL FEATURES
-External Fuse Holder
-Main Wiring Pigtail with Locking Amp Connector (12-Pin)
-Auxiliary Input Phone Jacks (Left and Right)
Manual contents: Page:
Features-Manual contents 1 Controls Identification 2-3 Operation Instructions 4-10 Hook Up Wiring Color Code 11 Installation/Specification 12 Warranty 13
1
Controls Identification:
Controls Identification
1) Tuning Up / Seek / Minute Set Button
2) Tuning Down / Seek / Hour Set Button
3) Mute / AS/PS / Loud Buttons
4) Time Set Button
5) Display Window
6) Alarm Set / Alarm On/Off Buttons
7) Button Reset
8) Preset # 3 (Previous) / Preset # 4 (Next)
9) Preset # 5 (Menu)
10) Preset # 6 (Enter)
11) Preset # 1 (Play/Pause) / Preset # 2 (Stop)
12) DVD Player
13) Eject Button
14) Speaker Selector
15) 1/8” Auxiliary Input Jack
16) Stereo Headphone Jack
17) Audio Adjust Button
18) Power Switch w/Volume Control
19) Source Selectors
20) Car Antenna Jack – 75 ohm
21) FM Antenna Terminals
22) RCA Auxiliary Input Jacks
23) Harness
2
Remote Controls Identification
Remote Controls Identification
1) Power
2) Source
3) Numeric Buttons
4) Mute
5) Tune Up
6) Tune Down
7) Previous
8) Left
9) Enter
10) Fast Reverse
11) Stop
12) Subtitle
13) Setup
14) Program
15) Audio (DVD)
16) Go To
17) Angle
18) Eject
19) Menu/Band
20) Audio Mode
21) Vol +
22) Vol –
23) Up
24) Next
25) Right
26) Down
27) Fast Forwarding
28) Play / Pause
29) Display
30) Title
31) Repeat
32) Time / Freq
33) Zoom
3
Operating Instructions:
NOTE: Number in parenthesis (#) corresponds with “Control Identification” on page 3.
Note : Power can be turned on by pushing any button on the front of the AWM950.
LIQUID CRYSTAL DISPLAY PANEL
The liquid crystal display (LCD) panel displays the frequency, time and activated functions. Note: It is characteristic of LCD panels that, if subjected to cold temperatures for an extended period of time, they will take longer to illuminate than under normal conditions. In addition, the visibility of the numbers on the LCD may slightly decrease. The LCD readout will return to normal when the temperature increases to a normal range.
TUNER
1) Turn power on by pushing the Power switch /Volume control button (18).
2) Use the Source Selectors (19), select the AM/FM button
3) Use the Speaker Selector Switch(14) to choose speaker output
4) Use the Tuner Up (1) or Down (2) buttons to select station manually. Also, the Station Preset buttons can select stations (this will be discussed later in the manual). Push either of the seek buttons (1 or 2) to tune to the next higher or lower active stati on.
5) Adjust Volume Control (18) to suit taste.
DVD PLAYER
1) Turn power on by pushing the power switch / volume control button (18).
2) Insert an available disc such as DVD, CD, or MP3 CD into the DVD player (12)
3) Use the Speaker Selector switch (14) to choose between speaker output, headphones or both.
4) Press the DVD Play/Pause button (11).
5) You may change tracks or chapters by using the Next or Previous buttons (8).
6) To change to AM/FM or Aux. Inputs, press the corresponding button; to return to DVD press the DVD button.
8) To eject the disc, press the Eject bu t to n ( 13).
AUXILIARY INPUT
1) Push Power Switch (18) “On”.
2) Using the Source Selectors (19), choose the b utton label ed “AUX”.
3) If there is an external source (example: CD shuttle or TV audio) connected to the Auxiliary Input Jacks (22) on the rear of the radio, then you can listen to your external source through the system.
SETTING THE CLOCK
1) Push Power Switch (18) “On”.
2) Press the T/F button (4) to display the clock
3) Hold the T/F button (4) and simultaneously use the H and M buttons (1 and 2) to adjust hours and minutes.
Note: The T/F also toggles between time and radio frequency on the display.
SETTING STATION INTO MEMORY PRESET
1) This unit has the ability to set 18 FM and 12 AM stations into memory.
2) To set the AM or FM stations into memory, first tune to the desired station.
4
Loading...
+ 9 hidden pages