Page 1
Model AVX1B4S
This transmitter is designed for use with your upgrade remote start
unit and is programmed by using the remote start's program switch in
combination with the transmitter button. Although this transmitter can
be programmed into any of the Audiovox remote start and or alarm,
alarm remote start systems, it will offer limited use and should be
used for the remote start upgrade only.
To program this transmitter into your remote start upgrade unit:
1. Turn the ignition to the on position
2. Press and release the programming switch 3 times
3. Press and hold, for 3 seconds, the button of the transmitter you
wish to add until the parking light flashes indicating the
transmitter has been learned.
4. Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.
NOTE: Do not allow more than 15 seconds to lapse between steps
or the program mode will be automatically exited and you will
have to start over.
The transmitter incorporates a small red LED visible through the case.
This LED can be used to indicate battery condition. You will notice a
decrease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to 12
months, depending upon how frequently the transmitter is used.
To replace the battery...
1. Remove the transmitter cover by removing the small screw from
the back of the transmitter case.
2. Remove the discharged battery or batteries, making note of the
orientation of the + and - contacts, and dispose of properly.
3. Install the new (type CR1220) batteries, taking care to orient the
+ and - contacts properly.
4. Replace the transmitter cover, taking care not to damage the LED
or switches on the circuit board.
Transmitter Programming Guide
128-7066
1 of 2
Page 2
ORDER FORM FOR TRANSMITTER A VX1B4S
Attention: Transmitter Ordering Department
Important: To help us expedite your order, please print all of
the information legibly and mail this form and your payment
according to the instructions below.
1) Name:___________________________________________
2) Address:_________________________________________
3) City:________________State:________Zip Code:__________
4 Telephone Number:( )_____________________
5) Total Number Of Transmitters Required:_______
Cost Per Transmitter is: $65.00
Multiply By Number Of Transmitters X
6) Enter Total Amount Enclosed _______
(New York State Residents must include the appropriate sales tax)
7) Method of Payment:
Mastercard Visa Check or Money Order (do not send cash)
Credit Card Number:___________________________________
Credit Card Expiration Date: ____/___/____
8) Mail this form along with your payment to:
Audiovox Corporation 150 Marcus Blvd., Hauppauge N.Y.
© 2004 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788
Make Checks Payable To Audiovox Corporation
Transmitter Ordering Department
11788
Credit card purchasers can order additional or replacement
transmitters by phone. Simply dial 1 - 800 - 645 - 4994, and
follow the instructions from the operator interface
2
128-7066
128-7066
2 of 2
Loading...