Jensen ANHD20RTL12 User Manual

w w w.JensenRVDirect.com

ANHD20RTL12 INSTALLATION guIde

Crank existing antenna to full elevation.

TOOLS & SUPPLIES

• DrillorBatteryDriverwitha#2Philipsbit

• PuttyKnife

• 3/32”Allenwrench

• ElectricalTape

• ExteriorRoofSealant(Non-hardeningtype)

Remove sealant & screws from base,

remove antenna and clean surface

Remove 3/32” set screw from crank. Remove crank,

spring, directional handle, & 4 screws.

Apply sealant to all holes & attach exterior plate

using the included hardware

10) Connect appropriate cables / wires and install new plate. Tape all coax connections

Refer to the ANHD20 Installation / Operation for additional installation details

ASA ELECTRONICS CORPORATION

www.jensenrvdirect.com www.asaelectronics.com

10) Connect appropriate cables / wires and install new plate. Tape all coax connections

Apply sealant to holes and attach base using the

7) Attach antenna to base and seal all seams and screws on plate and antenna base

8) Install interior plate using included hardware over hole in ceiling

10) Connect appropriate cables / wires and install new plate. Tape all coax connections

Refer to the ANHD20 Installation / Operation for additional installation details

included hardware.

Install interior plate using

included hardware over hole in ceiling.

ASA ELECTRONICS CORPORATION

www.jensenrvdirect.com www.asaelectronics.com

Refer to the ANHD20 Installation/Operation for additional installation details.

Apply sealant to 3 screws, ll coax hole, connect

coax to antenna and wrap connection with insulating electrical tape. Coax connection should be located inside vertical stalk of antenna for service.

Attach antenna to base and seal all seams and screws

on plate and antenna base.

Remove plate from wall and disconnect all wires and

cables (note power/ground polarity & cable labels).

Connect appropriate cables / wires and install new

plate. Tape all coax connections.

Specifications and Main Features