Bottom Mount Built-in Refrigerator
PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
JB36CXFXL
JB36CXFXR
JB36PPFXL
JB36PPFXR
JB36REFXL
JB36REFXR
JB36SEFXL
JB36SEFXR
Electrical: A 115 Volt, 60 Hz., AC only
15- or 20-amp fused, grounded electrical
JF42CXFXD
JF42PPFXD
JF42REFXD
JF42SEFXD
JB36SSFXL
JB36SSFXR
JF42SSFXD
Height dimensions are shown with the
leveling legs extended to 1/8" (3 mm)
below the rollers.
The water line attached to the back of
the refrigerator is 5' (1.5 m) long.
SIDE VIEW
A
23¹⁄₂"
(59.7 cm)
supply is required. It is recommended that
a separate circuit serving only your
refrigerator be provided. Use an outlet that
cannot be turned off by a switch. Do not
use an extension cord.
A grounded 3 prong electrical outlet should
be placed within 4" (10.2 cm) of the right
side cabinets or end panel.
Water Supply: A cold water supply with
water pressure between 30 and 120 psi
*83³⁄₈"
(211.8 cm)
84" (213.4 cm)
Power Cord
(207 and 827 kPa) is required to operate
the water dispenser and ice maker. If you
have questions about your water pressure,
call a licensed, qualified plumber.
The water shutoff should be located in the
base cabinet on either side of the
refrigerator or some other easily accessible
area. If the water shutoff valve is not in the
cabinets, the plumbing for the water line
can come through the floor or the back
wall.
Series A
Overlay Desgn 25-1/8" (63.8 cm)
Euro-Style or 25-3/8" (64.5 cm)
Pro-Style®Design
IMPORTANT: The pressure of the water
supply coming out of a reverse osmosis
system going to the water inlet valve of the
refrigerator needs to be between 30 and
120 psi (207 and 827 kPa).
If a reverse osmosis water filtration system
is connected to your cold water supply, the
TOP VIEW
NOTE: Add up to 2-11/16" (6.74 cm)
for the handles
.
41
¹⁄₄"
A Width
(105 cm)
water pressure to the reverse osmosis
system needs to be a minimum of 40 to 60
psi (276 to 414 kPa).
Do not install the refridgerator near an
Model Width A
36" (91.4 cm) 35-1/4" (89.5 cm)
42" (106.7 cm) 41-1/4" (105 cm)
oven, radiator, or other heat source, or in a
location where the temperature will fall
below 55°F (13°C).
DOOR SWING DIMENSIONS
The location must permit the door to open a minimum of 90°. Allow 4-1/2" (11.4 cm)
minimum space between the side of the refrigerator and a corner wall.
NOTE: More clearance may be required if you are using overlay panels.
23"
(58 cm)
max.
51"
(130 cm)
59"
(150 cm)
90˚
110˚
130˚
130˚
110˚
90˚
90˚
110˚
130˚
sledoM )mc 7.601( "24sledoM )mc 4.19( "63
¹⁄₂"
13
(34.3 cm)
max.
¹⁄₂" (8.9 cm)
*3
25³⁄₈"
(64.5 cm)
40⁷⁄₁₆"
(102.7 cm)
44¹⁄₄"
(112.3 cm)
FRONT VIEW
*83³⁄₈"
(211.8 cm)
36¹⁄₄" (92 cm)
42¹⁄₄" (107.3 cm)
* When leveling legs are fully extended to 1-1/4" (3.2 cm) below
rollers, add 1-1/8" (2.9 cm) to the height dimensions.
OPENING DIMENSIONS
To avoid tipping during use, the solid
soffit must be within 1" (2.5 cm)
maximum above the refrigerator. If the
solid soffit is higher than 1" (2.5 cm) or
¹⁄₂"
(1.3 cm)
one is not available, then the
refrigerator must be braced.
If the anti-tip boards are needed, they
must be attached to the rear wall studs
80" to 90" (203 to 229 cm) above the floor.
80" - 90"
(203-229 cm)
4"
(10.2 cm)
NOTE:
A clearance of 1/2"
(1.3 cm) must be
maintained in front
of the refrigerator’s
side trim in order for
83¹⁄₂" (212.1 cm) min.
³⁄₄" (215 cm) max.
84
to bottom of solid soffit
the top grille to be
removed.
NOTE:
Flooring under
77"
(196 cm)
refrigerator must
be at same level
as the room.
A
Width
(see chart following)
Model Width A
36" (91.4 cm) 35-1/2" (90.2 cm)
42" 106.7 cm) 41-1/2" (105.4 cm)
1"
24"
(60.96 cm) min.
(2.54 cm)
6"
(15.2 cm)
6"
(15.2 cm)
(15.2 cm)
6"
*83³⁄₈"
(211.8 cm)
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10183782A
9/21/12