Jenn-Air J31111WAV, J31111XAW, J31111XAV, J32111WAV, J32111XAW Dimension Guide

www.dexpress.com DIMENSION EXPRESS Fax on Demand [phone]

This Data Sheet Includes Information On

Jenn-Air

• Product Model Number (s): •

30"

Free Standing Gas Ranges:

J31111WAV, J31111XAW, J31111XAV, J32111WAV,

(not to scale)

J32111XAW, J32111XAV, J31213WAV, J31213XAW

and J31213XAV

• Dimensions (Actual Size) •

Height of cooking surface: 36"

Height overall:

Case width:

Depth NOT including handle:

Door swing:

44 7/8"
30"
26 5/32
20"
36"Height at full leg adjustment:

Height at 0" leg adjustment:

35 1/2"

• Additional Information •

• Units depth including door handle is 28 3/8".

44 7/8"

36"

20"

Door open

26 5/32

• Can be installed with the back against (0") a vertical

combustible wall, and the sides below the cooktop
surface against (0") combustible base cabinets.

• Electrical requirements: 120 VAC,60Hz. 15 amp

grounded circuit protection is required.

• Gas requirements: 1/2" NPT female inlet. Line MUST

Wall View

(not to scale)

1"

have an accessible shut off valve when range is
installed. Can be converted to LP gas without
additional parts.

• Proper operation requires use of range hood.

• Cabinetry over cooktop : 30' minimum clearance

between the top of the cooking surface and the bottom
of an unprotected wood or metal cabinet. 24" minimum
when bottom of wood or metal cabinet is protected by
not less than 1/4" flame retardant millboard covered
with not less than no. 28 MSG sheet steel, 0.015"

Locate gas line
within shadded

area

18"

28"

Electric

Location

Gas Location

Locate electrical
supply outlet (flush
with wall) within
hashed area. Area is
13" W X 9" H.
located 9 3/8" above
floor and 1 1/2" from
right wall.

stainless steel, 0.024" aluminum or copper.

• To eliminate the hazard of reaching over heated

surface units, cabinet storage space located above

2 1/2"

the surface units should be avoided. If cabinet storage
is to be provided, the hazard can be reduced by
installing a range hood that projects horizontally a
minimum of 5" beyond the bottom of the cabinets.

• For Free-standing installations the cutout opening

width is 30" ± 1/16" minimum. The height of the
countertop is 36" and countertop depth is 25".

Wall View

(not to scale)

30" Min.

Upper cabinets
can only be 13"
deep maximum.
Over range
cabinet is NOT
recommended.

• Island or peninsula installations with 24" deep base

cabinets must use flush back (no rear toe space)
cabinets to avoid range interference,. If rear toe space
is desired, use 27" or deeper cabinets.

• J31111WAV, J32111WAV and J31213WAV :

Designer White.

18"

• J31111XAW, J32111XAW and J31213XAW : White.

• J31111XAA, J32111XAA and J31213XAA : Almond

36"

Subject to change without notice. This system is designed to
be updated daily if necessary. Dimension Express is not
responsible for use of superseded, voided, or outdated data
sheets. Because of the difficulty or impracticability of deter­mining actual damages, liability of Dimension Express shall
not exceed $50.00.
Copyright © Dimension Express, 2000.

• NEVER reuse Data Sheets. Data Sheets are subject to change without • Call Dimension Express if you have any questions at [phone] •
notice. Dimension Express is a FREE service bureau and is updated daily, • Always refer to a current Code at a Glance or manufacturer directory •
it makes far more sense to spend the time necessary to request new Data • Data Sheet codes change on the first of odd numbered months at 12:01am •
Sheets for each project, as opposed to the problems, time, costs, and risks
associated with reusing old Data Sheets.

255

Countertop

height

30"

Side clearance
from cooktop to
18" above the
cooktop is 3" on
each side (see
solid arera)

Range

30" Minimum
cutout width

BN220.7 • A255 • 31469 • 002906 • 193313 • 67213